Installation Instructions

SPECIFICATIONS
Performance Level for Access Control
This product complies with the following UL 294, 7th edition Access Control
Performance Levels:
Feature Level
Standby Power I
Endurance IV Prox
I Bluetooth
Line Security I
Destructive Attack I
See the UL listed access control unit controller installation instructions for reader
compatibility.
Environmental
Operating Temperature -31°F to + 151°F (-35°C to +66°C)
Humidity 86 ±3°F (85 ±5% at 30 ±2°C)
Ingress Protection IP65 (not evaluated by UL)
Positioning Suitable for OUTDOOR use.
Electrical
Power supply Power is to be provided by a UL 294 Listed,
low-voltage Class 2 Limited Power Supply or
controller, capable of 4 hours standby.
Voltage +5Vdc to +16Vdc
Current maximum average measured at 10Vdc
Data Voltage Rest >4Vdc / Active <1Vdc
Data Output Wiegand, Open Supervised Device Protocol
(OSDP), OSDP Secure Channel (SC), F/2F
Indication 1 RGB LED
(+ RGB LED keypad to RX1K90B & RX3K90B)
Sounder Integral speaker
Dimensions
Wiring
Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70),
local codes, and the authorities having jurisdiction.
Cable length Up to 492 feet (150m) from controller.
Recommended for Wiring
Cable type BELDEN 953x (or equivalent UL listed) for Wiegand and (S)F/2F.
BELDEN 9502 (or equivalent UL listed) for RS-485.
Minimum wire size Not less than 24 AWG.
Shielding Connect the reader’s ground wire to cable shielding
and connect shield wires at the microcontroller.
All cables and wiring must be UL listed and suitable for use.
Installation
Installation of readers should be carried out by a suitably qualified engineer.
Readers are certified to be installed up to a height of 2 metres (approximately 79 inches).
It is recommended to install readers at a height of between: 1.2 metres - 1.5 metres
(approximately 47 inches - 59 inches).
RX190B
RX1K90B
RX290B
RX390B
RX3K90B
RX490B
Model Normal Standby mA Operating mA
30
50
30
30
50
30
65
110
65
65
110
65
RX190B
RX1K90B
RX290B
RX390B
RX3K90B
RX490B
Model Size - millimetres (inches)
87 x 87 x 21 (3.4 x 3.4 x 0.8)
87 x 87 x 21 (3.4 x 3.4 x 0.8)
144 x 54 x 21 (5.7 x 2.1 x 0.8)
120 x 76 x 21 (4.7 x 3.0 x 0.8)
120 x 76 x 21 (4.7 x 3.0 x 0.8)
96 x 52 x 21 (3.8 x 2.1 x 0.8)
100-02643-A-DEV02
RX490B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
RX390B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
RX3K90B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
RX290B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
RX1K90B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
RX190B
13.56MHz
LEGIC Connect
®
BLE (2.4GHz)
Wiegand and OSDP outputs
tm-readers.com [phone]
Specifications subject to change without notice.
Please turn over for fixing guide and wiring connections
©2020 - All rights reserved. 100-02942-B-English
i
Mounting this reader on (or near) metal may impair the
read range of the unit.
The Bluetooth word, mark and logo are registered trademarks of Bluetooth SIG, Inc.
Bluetooth
®
4.2 for use with:
• LEGIC Connect
®
API for:
• iOS version 10.0 and later
• Android OS version 6.0 and greater
INSTALLATION GUIDE
Connect® Security Platform
Bluetooth® enabled readers
reader IC
trusted service
infrastructure
mobile app
management
system