Date : 2019.07.02 TWA-RAD document number: INZ-190702-001 FCC ID : 2ADTG-TWARAD IC : 12594A-TWARAD TWA-RAD (RADAR) 2019.07 Inzinious, Inc.
Date : 2019.07.02 TWA-RAD 1. Device Overview 1 ) 24GHz-based K-band radar. 2 ) Integrated antenna and MCU. Small size and low cost. 3 ) Low power operation. 4 ) Provide GPIO interface. 5 ) Object movement recognition. 2. Basic Specifications 1 ) Power supply : DC 5V 2 ) Current consumption : 80mA 3 ) Operating temperature : -30 ~ 75 ℃ 4 ) Output power ( E I R P ) : 15 dBm 5 ) Antenna gain : 9 . 2 3 dBi 6 ) Detection distance : 5m 7 ) IF output : single-ended 8 ) Output frequency : 24.
document number: TWA-RAD Date : 2019.07.02 INZ-190702-001 3. Product Size 1) Width : 50mm 2) Height : 42mm 3) Diameter size : 42mm 4) Cable length : 4,500mm 4. Specification Specification Parameter Condition Unit Min. Typ. Max. Frequency 24.14 GHz Output Power (EIRP) 15 dBm Microwave Horizontal 65 80 110 deg Vertical 25 35 45 deg Sensing Coverage Horizontal ±30 ±40 ±55 deg Sensing Range Front (Car) 5 10 m 5 5.
Date : 2019.07.02 TWA-RAD document number: INZ-190702-001 5. Pin Description PIN Name 1 RADAR_OUT 2 GND Description High signal output when an object is detected. Ground Main supply voltage. 3 VDD_RADAR_5V (Only one of VCC_5V and VCC_3.3V should be selected and used.
Date : 2019.07.02 TWA-RAD document number: INZ-190702-001 6. Installation Method of the Device 1) The radar module is installed in the center of the top of the car glass. 2) Clean the glass of the car to which the module is attached. 3) Remove the adhesive tape protective film of the module. 4) Level the module and attach it to the mounting position. 5) Connect the module's cable to the dashcam's radar module connection port. 6) Turn on the dashcam and check if the module is working properly.
document number: TWA-RAD Date : 2019.07.02 INZ-190702-001 FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two interference, conditions: and (2) (1) this This device device must may accept not any cause interference harmful received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
document number: TWA-RAD Date : 2019.07.02 INZ-190702-001 IC Warning This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions : (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.