A iv. Timezone setting [res na b. Internet settings: i. WI-Fi settings: when the end user clicks on the WI-fi setting tap then they can configure their wife by their change the network add a network view the network information , and configure the network IP address if they chose to have it static IP.
A Er When the user clicks on the security tap then they can choose the type of the certificate they would like to connect to the device. The Flair device should self assigned the certificate after it is due to expire. Rie if.
<. The end user can also configure the setting manually, Bass Pee Sensors: i. The pie charts display the health of the two sensors located in the device. As their health goes down, so does the number and the pie chart. ii. Calibration and Resetting the Baseline: 1. C0; / Doc's reset baselines wire frame: a.
A This will reset te Baseline for the Yor Reading oF var mantas fee you sure you set to rector 1. When you press no, it should go back to the first page. And when you press on yes, it will show progress line as showing in the image below Bret in proves When the progress is finished, then it should show the below image for 3 seconds. After that the image should disappear automatically bring you back to the first page.
A . b. Resetting the CO2 baseline: Flagellate the C08 Basing vi Hl Heroics wi aie hs on. aon Nonunion sly Ba pas ll tie meanie pin. se ee i. When you click on cancel, this should bring you back to the first page. However, when you dick on start, that should start the resetting process as showing below: Note: The countdown seconds is based on the selection above which is 45 min. As well as the progress har, should be in count down. Use the old Flair device for reference.
A ii. Below as another example explaining the count down and the progress bar a ‘When the count down if finished, then the resetting baseline progress will start as showing below Reset in progress image showing a progress completed. Ee IRE 2.
what it is originally being read, then they can select the metrics they want and select + or — and enter the number. Another example, if the value if the AQ1 is 50, but the end user wants it to show on 30 on the screen, then the end user will select AQ! calibrate tuner 20 and select the ~ sign and click on the update button after they are done.
il. Orientation: This allows the end user to change the rightsize up or upside down. far Right Sid Up iii. Timeout: This allows the use to change the screen timeout settings: Tho Min e. Data points: Visibility, Units, and Alert i. Visibility: The visibility settings allow for users to directly adjust which data points they'd like to display on the dashboard.
A il. Units: Users can change the units they'd like displayed for specific data points. This will change both the dashboard units and internal screen units. ] ee iii. Alerts: The user can enable or disable alerts for all by using the top toggle, or change them individually by using the toggles below with their corresponding data points.
F. To preform factory reset, the device then asks for the last four digits of the serial number of the device. Gin pe i. Device details: end user can view the device detail and can also view and configure the connectivity methods, i. Device detail such as device 1D, serial number, manufacturer, model, firmware version and updates, enabling auto update and factory reset the device. il.