Ha rd wa re To p Vie w Bo tto m Vie w Wall m o unts Fro nt Vie w WAN inte rfac e LED Erro r LED Po we r LED 3G LED (o nly o n 3G m o d e l) Run LED LAN inte r fa ce LED ZigBe e inte r face LED Bac k Vie w LAN c o nne cto r AC/DC p o we r s up p ly Re s e t b utto n WAN c o nne c to r LED light overview LED Status Identification Power RUN ERROR ZigBee On (Green) On (Green) On (Red) Off Power On POST is successful POST fails ZigBee is disabled
On (Blue) Off On (Orange) Flashing (Orange) Ethernet WAN Port Link/ACT On (Green) Flashing (Green) Off On (Orange) Flashing (Orange) Ethernet LAN Port Link/ACT On (Green) Flashing (Green) ZigBee module is enabled No device is connected A 10/100 Mbps device is connected to the port A 10/100 Mbps device is transmitting or receiving to the port A 1000 Mbps device is connected to the port A 1000 Mbps device is transmitting or receiving to the port No device is connected A 10/100 Mbps device is connected to the
Installation What you need to get started 1 power cord (included) 1 Ethernet cord (included) INSTRUCTIONS 1. Determine your gateway’s Ethernet Mac address Look on the bottom of your gateway for the Ethernet MAC address and write it down. 2. Plug in modlet gateway Plug in the modlet gateway into an electrical outlet using the power cord provided. The green power LED light should turn on. Then plug the gateway into your home or office router using the Ethernet cord provided.
Troubleshooting If you are connected to the internet and logged into your account, but you’re not seeing the latest data, try these tips. 1.
For more troubleshooting information, call the modlet tech support center at 1-800-682-0152. Modlet® gateway PACKING LIST 1 modlet gateway TE1211E 1 Cable Ethernet, 6FT min 1 AC/DC Power supply, 110V/240V Input, 12V/1A output ThinkEco modlet® gateway Thank you for purchasing your new modlet® gateway! For more information and to learn about your modlet® gateway please visit www.themodlet.com.
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
OR COMPLETENESS OF THE TE PRODUCTS AND DOES NOT REPRESENT OR WARRANT THAT (A) THE USE OF TE PRODUCTS WILL BE SECURE, TIMELY, UNINTERRUPTED OR ERROR-FREE OR OPERATE IN COMBINATION WITH ANY OTHER HARDWARE, SOFTWARE, SYSTEM OR DATA, (B) TE PRODUCTS WILL MEET CUSTOMER’S REQUIREMENTS OR EXPECTATIONS, (C) ANY STORED DATA WILL BE ACCURATE OR RELIABLE, (D), TE PRODUCTS ARE FREE OF VIRUSES OR OTHER HARMFUL COMPONENTS.