Installation Instructions

Motion Quantum brings you the essence of digitalized motion.

The Oxygen

The kit includes:

 1 Nucleus – central unit

 8 Electrons – sensors

 2 charging cables for Electrons

 1 charging cable for Nucleus

 1 Nucleus holder

 Foam for sensor calibration

Interfaces of Nucleus and Electrons

LED

Mirco USB port for charging

Charging

To charge the devices plug them into the USB slot using a micro USB cable (on the

Nucleus/Electron side). Please note that the devices can be used while plugged in and

charging, but certain operations are not advised, like sensor calibration.

LED status

The LED mode on the Nucleus and Electron can change based on the battery, charging

and internal states. The battery and charging related LED modes can be seen in the

next table.

State of device

Corresponding LED behavior

Low battery (<10%)

Short red blink with 1s period

Charging

Green pulsating light with 1s period

Fully charged

Short green blink with 1s period

Turning on/off

1. The sensor can be switched on by connecting the sensor to a power source

through the micro USB connector (as if to charge the batteries).

PAGE 1
Motion Quantum brings you the essence of digitalized motion. The Oxygen The kit includes:       1 Nucleus – central unit 8 Electrons – sensors 2 charging cables for Electrons 1 charging cable for Nucleus 1 Nucleus holder Foam for sensor calibration Interfaces of Nucleus and Electrons LED Mirco USB port for charging Charging To charge the devices plug them into the USB slot using a micro USB cable (on the Nucleus/Electron side).
PAGE 2
. 3. The sensor can also be switched on by shaking it firmly (when using wake on motion). When awoken the led will light up. The Nucleus and Electron will switch off autmatically after 15mins if there are no active connections. Restart In case of restart the devices will lose any connection and ongoing measurement. Hard reset - upon connecting the device to a power source through the micro USB connector the device will reset.