User Manual

Table Of Contents

This product is intended for installation only by expert users. Please consult with a qualified technician for

installation. Improper installation may result in damage to your equipment.

1. Please carefully read the manual before beginning the installation process !

2. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000.

3. DO NOT USE any kind of alcohol or alcohol derivatives with this reservoir or the acrylic tube may crack

and fail ! Do not clean it using alcohol either !

Pacific

RL120

Before Installation

Water Cooling Kit

Cautions: Make sure there's enough space when you start set up the LCS product

To ensure a clean loop,

flush and rinse your radiators

and water blocks with

distilled water before using.

Make sure the fittings are

screwed securely when

placing them onto

the radiator.

Attach the fans to the radiator

Attach fittings onto the pump

and reservoir

Attach the fittings to the inlet and

outlet of the waterblock.

Attach the waterblock onto the

motherboard by referring to the

enclosed manual.

Radiators

Case Fan

Pump and Reservoir

Water Blocks

Installation Walkthrough (Example: Core V51)

Place the motherboard into the case. Position the radiator.

Attach the pump and reservoir into

the chosen locations.

PAGE 1
Water Cooling Kit Pacific This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. 1. Please carefully read the manual before beginning the installation process ! 2. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. 3.
PAGE 2
Cutting and Attaching the Tubing 1 Take out the cap from the fittings and place the cap of the compression fitting over the tubing. Push the end of the tubing over the barb; make sure the tubing is a tight fit. Slide the cap over the fitting and rotate it clockwise until the tubing is sealed in place. 4 Connect the tubing and check all the fittings are sealed. The loop order: radiator > Reservoir Inlet 2 Connect the tubing and check all the fittings are sealed.