Installation Instructions

ManualsBrandsTheGodThings ManualsElectronicsPrinCube

PrinCube Manual

1. Start/Stop Button

2. Status Indicator

3. Print Head Nozzles

4. Optical Sensor

5. Open/Lock Toggle

6. Roller

7. ON/OFF Toggle

What's In The Box

• PrinCube

• Base Dock

• Clean Brush

• PrinCube Standard Ink Cartridge

• Advanced Printing Holder

• Two Rulers

• Type-C Charging Cable

• PrinCube Manual

Basic Operation

Install cartridge

1. Remove the protective case and protective film on the ink cartridge;

2. Remove the printer base and pull the toggle switch to ‘OPEN’, then open the transparent

cover;

3. Put the cartridge into the printer's ink tank, making sure that it’s fully secured. Close the

transparent cover and pull the toggle switch to ‘LOCK’.

Notes:

Summary of content (5 pages)

PAGE 1
PrinCube Manual 1. Start/Stop Button 2. Status Indicator 3. Print Head Nozzles 4. Optical Sensor 5. Open/Lock Toggle 6. Roller 7. ON/OFF Toggle What's In The Box • PrinCube • Base Dock • Clean Brush • PrinCube Standard Ink Cartridge • Advanced Printing Holder • Two Rulers • Type-C Charging Cable • PrinCube Manual Basic Operation Install cartridge 1. Remove the protective case and protective film on the ink cartridge; 2.
PAGE 2
• To open and lock the transparent cover, keep the cover in the closed position and then toggle the switch; • If the ink cartridge is not used for a long time, it is recommended to put it back in the cartridge protective case. Open APP 1. Turn on the power switch on the bottom of the printer and wait for 5 seconds to get ready to go with a beep. Connect through WiFi: 2. Search for WiFi with your device (such as a mobile phone). Find ‘PrinCube-XXXX’ and connect. (Default password: 12345678) 3.
PAGE 3
. Place the printer on the surface of the object to be printed. 4. Click the button, the green indicator light is on, and it’s ready to print. 5. Slide the printer to the direction you want to complete the print operation. The green light goes off when it’s finished.
PAGE 4
• Press and hold the button, then turn on the power switch to enter the programming mode; • After turning on the power switch, press and hold the button within 5 seconds until the white lights flash on both sides, the WiFi name and password will be restored to the default setting (Default password: 12345678); • When the battery is low, the middle white light flashes; • The charging indicator is next to the USB port (Type-C).
PAGE 5
Notes: • Software features need to be used online first before they can be used offline. Installed Certificate in iOS 1. Click the certificate link on the APP Settings page to download the certificate. 2. Goto Settings > Profile Downloaded > Install the certificate. 3. Goto Settings > General > About > Certificate Trust Settings. Under "Enable full trust for root certificates," turn on trust for the downloaded certificate. Installed Certificate in Android 1.