Datasheet: BD 200
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • Germany • www.thomann.de
DocID: 436138_30.04.2018
Intended use
This device is intended to be used to convert acoustic signals to elec-
tric signals. Any other use or use under other operating conditions is
considered to be improper and may result in personal injury or prop-
erty damage. No liability will be assumed for damages resulting from
improper use.
DANGER FOR CHILDREN
Ensure that plastic bags, packaging, etc. are properly disposed
of and are not in the reach of babies and young children. Chok-
ing hazard! Ensure that children do not detach any small parts
from the product. They could swallow the pieces and choke! Never let
children use electrical devices unattended.
PROTECT THE ENVIRONMENT
Disposal of the packaging material
For the transport and protective packaging, environmentally
friendly materials have been chosen that can be supplied to
normal recycling. Ensure that plastic bags, packaging, etc. are
properly disposed of. Do not just dispose these materials with your nor-
mal household waste, but make sure that they are fed to a recovery.
Please follow the notes and markings on the packaging.
Disposal of your old device
This product is subject to the European Waste Electrical and
Electronic Equipment Directive (WEEE) in its currently valid
version. Do not dispose of your old device with your normal
household waste. Dispose of this product through an ap-
proved waste disposal rm or through your local waste facility. Comply
with the rules and regulations that apply in your country. If in doubt,
consult your local waste disposal facility.
DocID: 143725_16.12.2020
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • Germany • www.thomann.de
EN
Never remove the screen holding the capsule,
as this may damage the microphone!
Never drop the mic, as this may cause severe damage!
When the microphone is not in use, take it out of its
clamp and put it in its carton box. Clean with damp
cloth only.
Dynamic drum & brass mic - BD 200
9 Also well suitable for guitar
9 Metal construction
9 Includes clamp
Connection / Supply XLR
Transducer concept dynamic
Directivity super-cardioid
Field sensitivity [mV/ Pa] 1.8
Field sensitivity [dB re 1V/ Pa] -55
Equivalent noise level [dB(A)] 16.1
Signal-to-noise ratio [dB(A)] 77.9
Maximum SPL [dB SPL @ 1% THD] > 155
Electric impedance [ohm @ 1 kHz] 400
Frequency response 0.1 m -10 dB 20 – 16,000 Hz
Weight 265 g
Polar pattern @ 1 kHz
Normal use / proximity eect