Room Divider Installation Instructions www.slidingdoorco.com All Rights reserved by The Sliding Door Company, Inc. Materials and information contained herein may not be used for any other purpose. © 2021 The Sliding Door Co. SPACE PLUS is a division of The Sliding Door Co.
PG 02 Tools Required: You will need the following tools: The number of individuals required is based on the weight of your panel. We recommend at least 2 able individuals.
PG 03 Becoming Familiar with your Room Divider System: (Open-Air System shown with Upper Beam) Fig.
PG 04 Installing the Upper Track: 1. Measure the width of the top of the opening. Mark your upper track at this dimension. 2. Using the metal saw, cut the upper track, if needed, at the mark made in the previous step (the width of the top of your opening). See Figure 3. 3. Mark the locations of the pilot holes on top of the track. The first hole should be 3” in from the end of the track, centered within a channel. Make a mark every 16” through the rest of the track, in alternating channels. See Figure 4.
PG 05 Fig. 10 Alignment for all tracks are the same from the front of the track. Recessed Track Ramped Track Regular Track Header Header 1" 8 1" 8 Upper Track Front of Opening Header Upper Track Front of Opening Front of Opening 1" 1" 8 Upper Track 1" 7/16” Bottom Track Finished Flooring 3/8” Bottom Track Finished Flooring Installing the Bottom Track: 1. Measure the width of the bottom of the opening. Mark the bottom track at this dimension. See Figure 8. 2.
PG 06 Fig. 13 Fig. 14 Fig. 15 Groove Vertical Position Dust Strip and Upper wheels accessible when panel is laid on side Strip should not extend beyond the horizontal frame Top of panel Horizontal Position Soft Surface Fig. 16 Installing the Panel: Top of panel If the system you are installing is telescoping, please see separate instructions for installing bottom wheels. Wheels point inward. Wheels point outward. 1.
PG 07 Fig. 21 Fig. 22 Allen Wrench Tilt Adjustment Screw Screw(s) + Star Lock Washer(s) Phillips Head Screwdriver Adjusting the Doors: If the doors do not align properly with the sides of the opening, adjust the door tilt. 1. With the provided Allen wrench, loosen or tighten the black screw located above the wheel mechanism. Loosening the screw will lower the panel, while tightening it will raise it. See Figure 22. 2.
PG 08 Installing the Door Parks Tools Legend: The following tools are needed: 3 1 4 2 Recommended Mounting Hardware: 1 Pencil 2 Tape Measure 3 Electric Drill 4 1/8” Drill Bit METAL ATTACHMENT: #8 x 1-1/4” Phillips Pan Head Sheet Metal Screws (provided) Read these instructions completely before starting. The door parks will be located in a small box inside the larger door box. There will be 2 door parks per every panel. Door Parks may be used: A.