Installation Sheet

ManualsBrandsThe Great Outdoors ManualsLightingRond Single Light 8-3/4" High Outdoor Wall Sconce with Crackled Glass Shade

INSTALLATION INSTRUCTIONS

Item#71231/71232-661 (New. 05/02/2017)

READ AND SAVE THESE INSTRUCTIONS

W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

Fig.3

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and

remove old fixture, including the mounting

hardware.

2. Carefully remove the fixture from the carton and

check that all parts are included as shown in the

illustration.

3. Remove screw (E) from holder (F), then remove

glass shade (H).

4. Attach mounting plate (A) using the mounting

screws (B) (Size: #8-32N*L0.5”) to the junction

box. The side of the mounting plate marked

“GND” must face out.

CONNECTING THE WIRES (Fig. 2)

5. At this point, connect the electrical wires as shown

in Fig. 2, making sure that all wire connectors are

secured. If your outlet box has a ground wire

(green or bare copper), connect the fixture’s

ground wire to it. Otherwise, connect the fixture’s

ground wire directly to the mounting plate using

the green screw provided. After wires are

connected, tuck them carefully inside the junction

box.

FINISHING THE INSTALLATION (Fig.1)

6. Place the fixture body (D) over the mounting plate

(A), fastens with screws (C).

7. To prevent moisture from entering the outlet box

and causing a short, use clear caulking (i.e.

Indoor/Outdoor Silicone Sealant) to outline the

outside of fixture back-plate where it meets the

wall leaving a space at bottom to allow moisture a

means to escape (Fig.3).

8. Install the light bulb(s) (G) (not included) in

accordance with the fixture’s specification. (DO

NOT EXCEED THE MAXIMUM WATTAGE RATING!)

(NE PAS DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!)

9. Insert glass shade (H) into holder (F) and secure

shade (H) assembly by adjusting each screw (E)

into holder (F).

Your installation is now complete. Return power and

test the fixture.

Note: Illustration (Fig.1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2773E

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Green or

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

Set#A-021-140

-Mounting Plate

-Ground Screw

-Mounting Screw*2

CAULKING

BACKPLATE