Setup Guide gb was here Raumfeld Speaker L For a detailed online manual, visit http://manual.raumfeld.
Contents General Notes and Information............ 4 Integrating Your Music Collection........ 15 Overview............................................. 5 Frequently Asked Questions................ 16 System Requirements............................ 6 Advice on Safe Use & Maintenance..... 20 Connections & Operational Controls...... 7 Cleaning & Maintenance..................... 22 Operation Modes................................. 8 Environmental Protection.................... 22 Installation..........
General Notes and Information Notice 2. Serial number or batch number The information in this document may be changed without prior notice and in no way constitutes any liability on the part of Lautsprecher Teufel GmbH. No part of these instructions may be reproduced in any form or be broadcasted in any way electronically, mechanically, by photocopy or recording without the written permission of Lautsprecher Teufel GmbH. Visible on the back side of the device, e.g.
Overview Package Contents aa b a 1 x Active speaker b 1 x Passive speaker 1 x Speaker cable (5m) 1 x Power cable 8 x Speaker feet • Please check if your shipment is complete and not damaged. • Should your shipment be incomplete or damaged, please contact our service department before use (see page 4).
System Requirements System requirements • For initial setup and music playback control: The Raumfeld Controller OR the Raumfeld Controller App for your Smartphone or tablet • For integration into your home network: Network router with DHCP OR RAUMFELD CONTROLLER DHCP ROUTER • For wireless music playback: A Raumfeld Base OR Wi-Fi router (IEEE 802.
Connections and Operational Controls Active speaker: Passive speaker: 5 6 7 8 9 10 11 12 13 1 234 Active speaker 1 2 3 4 5 6 7 8 9 Volume control Power-LED System-LED On/Off button Reset button Setup button USB port (master, type A) Network connector Audio input analogue (RCA) 1 10 11 12 13 Voltage switch Main power switch Power cable socket Clamps for speaker cables Passive speaker 1 Clamps for speaker cables 7
Operation Modes Overview System mode Setting the mode Mode characteristics On Briefly press On/Off button with the main power switch turned on Powersave System reverts automatically to powersave when inactive Amplifier off, CPU throttled Sleep Mode Briefly press On/Off button Amplifier, CPU and WLAN off Off Turn main power switch off All modules off Operation mode Power LED System LED Starting Off On On / Powersave On On No Connection to the Raumfeld System On Flashing Off / Sleep
Installation Connecting the Raumfeld Speaker L 1. Position the two speakers in your room and connect them to each other using the speaker cable provided. ≥ You can choose which of the two speakers you want to control with the left stereo signal, and which with the right, at a later stage. ≥ Please make sure that the colour coding of the cables match the connectors on each speaker, as the wrong polarity will have an adverse effect on the sound.
Installation 4. 10 Briefly press the On/Off button on the front of the active speaker to start the device. Continue when the System LED (right) starts blinking.
Installation Connecting the Wi-Fi antenna In order to protect the Wi-Fi antenna from damage during transport we have removed it from your Raumfeld Speaker. Please be sure to connect the antenna before operating the device. The screw connector for attachment of the WLAN antenna is in the left hand corner on the back of the active speaker - directly to the side of the Teufel logo. 1. Place the screw nut at the bottom of the antenna in straight alignment against the threaded attachment of the active speaker.
Setup: New Raumfeld System 1. Installing the Raumfeld App Installation can be carried out using the Raumfeld Controller and, optionally, a smart phone or a tablet. If you would like to set up the Raumfeld Speaker with your smart phone or tablet, please first install the Raumfeld Controller App on your device. You can download a free version for iPhone, iPod touch, and iPad from the App Store.
Setup: New Raumfeld System 3. Following the setup wizard Please follow the wizard steps in order to set up your Raumfeld Speakers. Do you own a Raumfeld Base? In the beginning of the setup wizard you are asked if you own a Raumfeld Base. Please check carefully if your order contains a „Raumfeld Base“. The Base is an optional Raumfeld component which is recommended to be used as Wi-Fi access point in a multiroom setup. You can easily recognize the Base by its two antennas and three LEDs.
Setup: Extending Your System Adding to an existing system Should you wish to add the Raumfeld Speakers to a system that has already been set up, follow these instructions: 1. Take the Raumfeld Controller and switch it on, OR start the Raumfeld Controller App on your smart phone or tablet. 2. Go to “Settings > Room configuration”. Then select “Add room > Raumfeld Speakers“. 3. Follow the instructions on the display to connect the speakers to your Raumfeld system, and to assign a room name to them.
Integrating Your Music Collection There are several possibilities for you to integrate your music collection into the Raumfeld system. Copying music onto the Raumfeld Base If you have a Raumfeld Base, you can save your music collection on the internal hard drive of the Base.
Frequently Asked Questions You can find a full list of frequently asked questions as well as a detailed online manual online at: http://manual.raumfeld.com. General questions Question 1: Where can I find internet radio? ≥ TuneIn offers you free access to a wide range of internet radio stations from all over the world. For radio stations which are tailored specifically to your own taste of music, try the music service Last.
Frequently Asked Questions • If you are setting up a system with the Raumfeld Base, make sure that your router is connected to the network socket of the Base on the right, the one which is labelled “ROUTER”. Installation using the Raumfeld App Question 1: The App does not connect to the Raumfeld system during setup. What can I do? 1. First check if all system requirements are in place. 2. Make sure that the smart phone or tablet with the App installed is connected to your Wi-Fi router. 3.
Frequently Asked Questions 3. the Controller by holding the on/ off key pressed down (at least 10 seconds). Restart your Wi-Fi router by temporarily disconnecting it from power supply. Then start the setup from the beginning. When being prompted „Do you own a Raumfeld Base?“, carefully check if your order contains a Raumfeld Base (also see page 13) and choose the appropriate path in the setup wizard. Question 2: The Controller does not react any longer.
Frequently Asked Questions restriction does not apply to the Raumfeld Base. Question 4: Music from my media server is displayed unreliably and playback keeps being interrupted. What can I do? ≥ With certain music servers, compatibility problems can arise. In order to avoid such problems quickly, we recommend you include the content of the media server via file sharing (see also page 15). In this case, please also inform our customer service team.
Advice on Safe Use and Maintenance Warning icons The following symbols can be found in this guide: Danger High Risk! Disregard for this warning can cause life threatening damage. Attention Middle Risk! Disregard for this warning can cause damage to the product. Low Risk! Procedures that should be observed while handling the product. • • • • Advice on Safe Use Danger Electrical Shock Hazard! Faulty installation or high voltage may lead to electrical shock.
Advice on Safe Use and Maintenance Danger Child Safety! Children can get caught in the packaging materials and suffocate. • Never let your children play with the device or its packaging material. There is a risk of suffocation. • Make sure that your children do not remove or pull small pieces from the device (such as cables or buttons), as they may swallow the piece and choke. Should your child have swallowed a small piece of the device, immediately contact your local hospital.
Cleaning and Maintenance Clean the device regularly with a soft, lightly damp micro fiber cloth. Pay close attention to the following details: • Use as clear of a water as possible without any cleaning product. By stubborn spots use a mild combination of water and soap. • Under no circumstances should harsh cleansers, alcohol, paint thinner, gasoline, or similar substances be used for cleaning.
? Do you have any questions or problems in setting up your Raumfeld system? Contact our customer service for help! Phone E-Mail 00800 - 200 300 40 (free of charge) raumfeld@teufelaudio.com Please have the following information ready: • • • Customer number Brand, model, and manual of your router LED status of your Raumfeld products All trademarks are the property of their respective owners.
