User Manual

Wireless Phone Charger- WC3
The wireless phone charger can charge your Qi-enabled smartphone at up to 15W of power. Just simply
place your smartphone on the charger. The wireless phone charger supports up to two phones at once,
charging side by side.
NOTE: The wireless charger may not work if your phone case is metal. Take the phone out of the case and
place the phone on the charger.
FCC and IC Certification
Component Manufacturer Model
Operating
Frequency
(MHz)
FCC ID IC ID
Wireless
Phone
charger
Tesla, Inc.
WC3
2AEIM-WC3 20098-WC3
1.
This device may not cause harmful interference; and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by Tesla could void your authority to operate the
equipment
Note: Radiation Exposure Statement
The product comply with the FCC/IC RF Exposure for Low Power Consumer Wireless Power
Transfer. RF exposure limit set forth for an uncontrolled environment and are safe for intended
operation as described in this manual. The further RF exposure that compliance was demonstrated
at 20cm and greater separation from the user body or set the device to lower output power if such
function is available.
122.72~132.72kHz
The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license-
exempt RSS Standard(s) and EU Directive 2014/53/EU.
Operation is subject to the following two conditions:

Summary of content (4 pages)