Desktop KeyReader Plus Operating Manual Desktop KeyReader Plus Operating Manual Desktop KeyReader Plus ©TeraTron GmbH DesktopKeyReaderPlus_EN.docx Page 1 of 12 Document Version 1.
Desktop KeyReader Plus Operating Manual Table of Contents 1. Introduction ..................................................................................................................................... 3 1.1. Setup........................................................................................................................................ 3 1.2. Display and Control Elements ................................................................................................. 4 2.
Desktop KeyReader Plus Operating Manual 1. Introduction Desktop KeyReader Plus is a stationary device for reading out the vehicle data stored in the vehicle key. Once successfully read, the data is transmitted to a USB-connected PC. From there, the data is transmitted to a target system (KAI server). The USB connection also ensures the power supply. DesktopKeyReader KeyReaderPlus Plus Desktop USB Desktop DesktopPC PC KAI server LAN/WLAN Figure 1: Typical system configuration 1.1.
Desktop KeyReader Plus Operating Manual 1.2. Display and Control Elements Desktop KeyReader Plus features a white LED (status LED) on the front left and a multicolor LED (key LED) on the front right.
Desktop KeyReader Plus Operating Manual 2. Mechanical Design 1 2 4 3 Figure 2: Top view 1) 2) 3) 4) USB cable with type A plug connector Round vehicle key tray Status LED indicating operating mode(s) Key LED indicating recognition/upload status or device upgrade status 1 2 Figure 3: Rear view 1) Grommet for USB cable 2) Rubber plug Operating Manual Desktop KeyReader Plus ©TeraTron GmbH DesktopKeyReaderPlus_EN.docx Page 5 of 12 Document Version 1.
Desktop KeyReader Plus Operating Manual 3. Status LED Overview Status LED (left LED): Off No USB connection to PC. USB cable is not plugged in. Solid white USB connection is OK. Communication with ITOOLS-USBTrayApp established successfully. Fast blinking white USB connection is OK. Communication with ITOOLS-USBTrayApp could not be established. Slow blinking white USB connection is OK. VIN mode is active. Key LED (right LED): Off No key detected. Slow blinking green Key data uploading.
Desktop KeyReader Plus Operating Manual 5. Operating Desktop KeyReader Plus 5.1. Reading the Vehicle Key When the status LED is on, you are free to place a key on the Desktop KeyReader Plus tray. The entire key must fit within the tray and must be positioned flat. The direction the key is pointing is irrelevant (see images below). Do not move the key while it is being read. Since Desktop KeyReader Plus is constantly scanning for different key types, it may take a while for the reading process to start.
Desktop KeyReader Plus Operating Manual second confirmation signal sounds, and the LED light glows solid green for four seconds. (The upload time depends on the key and the amount of data stored, and may vary by several seconds). Due to the large number of supported key types, it is difficult to recommend a single, universal procedure. As such, the scenarios illustrated are intended merely as a general guideline. Data is transmitted exclusively via USB.
Desktop KeyReader Plus Operating Manual 6. Troubleshooting • Desktop KeyReader Plus fails to read the key data even though the left LED indicates that the device is ready. Please check that - the USB port being used supplies a minimum of 500mAh (USB 2.0 standard) - the USB cable is not plugged in to a passive USB hub - the USB cable has not been extended using another cable. Operating Manual Desktop KeyReader Plus ©TeraTron GmbH DesktopKeyReaderPlus_EN.docx Page 9 of 12 Document Version 1.
Desktop KeyReader Plus Operating Manual 7. Regulatory Notes Desktop KeyReader Plus complies with the approval regulations of the following countries: Radiofrequency radiation exposure Information: This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
Desktop KeyReader Plus Operating Manual This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Desktop KeyReader Plus Operating Manual Hereby, TeraTron GmbH declares that the radio equipment type Desktop KeyReader Plus (KR0304) is in compliance with Directive2014/53/EU. Operating Manual Desktop KeyReader Plus ©TeraTron GmbH DesktopKeyReaderPlus_EN.docx Page 12 of 12 Document Version 1.