User's Manual

Scan Function
Scan function is activate in No. 16 channel, stop
to scan after exiting No.16 channel.
VIII
VII
Breathing Light
After standby for 10S, the breathing light is
activate. It will lighting each 5S.
Care and Cleaning
To guarantee optimal performance as well as a
long service life of the product, please follow the
tips below.
Do not puncture or scratch the product with
hard objects.
Do not place the product in corrosive agents,
solutions or water.
Do not handle the radio by its antenna or
external microphone directly.
When not in use, keep the accessory jacks
covered with the protective caps.
Power off the product, and remove the battery
before cleaning.
Clean up the dust and fine particles on the
product parts with a clean and dry lint-free
cloth or a brush regularly.
Use a non-woven fabric with neutral cleanser
to clean the keys, control knobs, and shell
after long-time use.
Do not use chemical preparations such as
stain removers, alcohol, sprays or oil
preparations.
Make sure the product is completely dry
before use.
I
Power On/Off
Long press "Power On/Off" Key for 2 seconds to
turn on/off the radio.
Channel Selection
Short press "Channel +" to increase the channel
number.
Short press "Channel - " to decrease the channel
number.
II
Long press 2S
Short press
Monitor Function
Long press "Channel - " for 1.5S, then monitor
function is activate, you can listen to the channel
you selected whether someone is talking, if there
is no signal, you will hear the sound of rustling.
IV
Press "PTT Key / Side PTT Key" to transmit,
release to exit.
Push To Talk
III
Long press
Long press 1.5S
Long press "Channel + " for 1.5S to know the
current channel.
Volume Adjust
Toggle "Volume +" to increase the volume,
toggle "Volume - " to decrease the volume.
You will hear a beep sound when the volume
is maximum or minumum.
Volume Level: 0-7, you can set by programming
software.
VI
V
Current Channel Broadcast
Long press 1.5S
Toggle
ULTRA THIN TWO WAY RADIO
USER MANUAL
9
10
11
12
13
14
Microphone
PTT Key
Breathing Light
Speaker
Antenna
Side PTT Key
Channel +
Channel -
Volume Key
MIC Jack
Earphone Jack
USB Charging Port
Power On/Off
Battery
Basic Information
1
5
6
7
8
2
3
4
Basic Parameter
Dimension: 130x52x21.5mm
Weight: 80g
Storage Channel: 14CH
Operating Voltage: 3.3-4.2V DC
Operating Temperature: -10℃~-40℃
Radio Body x1，Battery x1，Adaptor x1，
Charging Cable x1, Belt Clip x1，Hand Strap x1，
User Manual x1
Including
Channel List
Channel Frequency Model Channel Frequency Model
1 462.5625 FRS
12 467.6625 FRS
2 462.5875 FRS
13 467.6875 FRS
3 462.6125 FRS
14 467.7125 FRS
4 462.6375 FRS
5 462.6625 FRS
6 462.6875 FRS
7 462.7125 FRS
8
467.5625 FRS
9
467.5875 FRS
10
467.6125 FRS
11
467.6375 FRS
Note: 8-14 channels must not exceed 0.5 W.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determind by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the follwing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
■Licensing

Information

MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This radio complieswith IEEE and ICNIRP exposure limits for General Population/Uncontrolled Environments RF
exposure emvironment at operating duty factors of up to 50% and is authorized by the FCC for General Population
use only. An appropriate warning lable is affixed to all units. In order to comply with RF exposure requirements, a
minimum distance of 2.5 cm must be maintained when held-to-face, and body-worn operations are restricted to the
approved original acessories (belt clip), a minimum distance of 0 cm. Do not use this device when antenna shows
obvious damages.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not
cause harmful interference.
SERVICE SIGNALS IS
PROHIBITED UNDER FCC RULES AND FEDERAL LAW.
IMPORTANT