User's Manual

ManualsBrandsTenvis Technology ManualsCamera & PhotoIP CAMERA

Pan Tilt

WiFi Pan Tilt Camera

BEFORE YOU BEGIN

Please unpack the box carefully and identify that all the parts are present.

The Camera is suitable for indoor use.

Check the voltage of the power supply. Make sure you use the recommended power

input (5.0V DC, 1.5A). Use of incorrect voltage is not covered by the warranty.

Do not attempt to open the casing to access the Camera. Damage caused to the

product by tampering with the casing is not covered by the warranty.

Do not aim the camera at the sun or similar intense light.

The interval time of powering the camera on and off must be more than 10 seconds

otherwise it will cause serious damage to the CPU.

When you update the cameras, please ensure you:

- connect the camera directly to a computer using a network cable

- close other programs and windows on the computer

- keep the power connected when updating the firmware

PT7131/PT7131W

PT7131 v1.0

Summary of content (6 pages)

PAGE 1
Pan Tilt WiFi Pan Tilt Camera PT7131/PT7131W B E F OR E Y OU B E GIN Please unpack the box carefully and identify that all the parts are present. The Camera is suitable for indoor use. Check the voltage of the power supply. Make sure you use the recommended power input (5.0V DC, 1.5A). Use of incorrect voltage is not covered by the warranty. Do not attempt to open the casing to access the Camera. Damage caused to the product by tampering with the casing is not covered by the warranty.
PAGE 2
PR OD U C T D E S C R I PT IO N WiFi Pan Tilt Camera can be set up in minutes for instant monitoring and live viewing on your Mac or Windows computer and 3G Smartphone - all via your wireless network router or switch For optional recording, simply install the recording software to your Windows PC and configure it to your particular requirements.
PAGE 3
P A C K A G E C ONT E N T S Power Adaptor WiFi Camera with Antenna Software Installation CD C A M E R A I N S T A L L AT ION 1. Begin by screwing the antenna and bracket to the camera and power the camera using the power supply provided. 2. Using a standard Ethernet network cable, connect the camera to your wireless network. The camera can either be connected to a router/switch or directly to a PC with an Ethernet network cable.
PAGE 4
CA M E R A S E T U P co n t i n u e d Please note that if you are using the camera on a wireless network you will need to first configure the camera for wired use, before you programme your wireless settings in to it. 1. Insert the Installation CD into your PC CD drive and the installation screen should appear automatically. If it does not, click ‘Start > Run> Browse...’ to locate the CD on your computer . 2. Double click ‘IPCamSetup.exe’ and install the software as instructed. 3.
PAGE 5
CA M E R A S E T U P co n t i n u e d After searching, the software will give one of 3 results: Connected IP cameras are located on the LAN - All the IP cameras will be listed and will be displayed in the result field as shown below. No IP Camera found within LAN - After about 1 minute search, the result field will show ‘Not Found IP Server’ and the software application will shut down automatically. The IP Cameras installed within LAN do not share the same subnet with the monitoring PC.
PAGE 6
CA M E R A S E T U P co n t i n u e d Network Configuration Configure the Network parameters from this page. • DHCP checkbox: If checked, the device will obtain an IP from the DHCP server (ensure the Router, with which the device connects, has a DHCP function). • IP address: Fill in the IP address assigned and make sure it is in the same subnet as the gateway (i.e. the first three sections are the same). • Mask: The default subnet mask of the equipment is: 255.255.255.