User's Guide
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may
cause undesired operation.
Warning: Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to
which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiati on Exposure Statement:
Warnings: Failure to heed the warning below could result in an
accident or medical event resulting in death or serious injury
Important Safety and Product Information:
!
FCC Radiation Exposure Statement:
T
his equipment complies with FCC radiation exposure limits set forth for a
n
u
ncontrolled environment. This equipment should be installed an
d
operated with minimum distance 20cm between the radiator & your body.
Industry Canada (IC) Information
T
his device complies with Industry Canada licence-exempt RSS standard(s)
.
O
peration is subject to the following two conditions:
(
1) this device may not cause interference, and
(
2) this device must accept any interference, including interference that ma
y
c
ause undesired operation of the device."
L
e présent appareil est conforme aux CNR d'Industrie Canada applicable
s
a
ux appareils radio exempts de licence. L'exploitation est autorisée
au
x
d
eux conditions suivantes :
(
1) l'appareil nedoit pas produire de brouillage, et
(
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectriqu
e
s
ubi, même si le brouillage est susceptible d'en compromettre l
e
f
onctionnement."
Gateway User’s Guide
The Tenovi Gateway contains electrical equipment that could cause injury if not
h
andled properly.
A
lways consult your physician before beginning or modifying any exercis
e
p
rogram.
D
o not allow children or pets to play with the Tenovi Gateway. The produc
t
c
ontains small components that can be a choking hazard.
D
o not attempt to replace any parts or open the enclosure. Doing so will voi
d
t
he warranty.
D
o not use abrasive cleaners to clean your product.
O
nly use an authorized Tenovi charging cable to charge your Gateway.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to
which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AZT4-TEN52832