Replace Rear Squeegee Caster Wheel Assembly

ManualsBrandsTennant ManualsMachinesBattery-Powered Ride-On Floor Scrubber

IB 9014333 (09- 2016) 1

INSTRUCTION BULLETIN

No. 9014333

Machine: M17 / T17 /

M20/T20/M30

Published: 09- 2016

Rev. 00

NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the

Parts List in the appropriate place in the machine manual for future

reference. Retaining the Parts List will make it easier to reorder

individual p arts and will save th e cost of ordering an entire kit.

NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.

Installation instructions for kit number 9014285

SYNOPSIS:

This kit contains the parts needed to replace a rear squeegee caster wheel assembly on T17 / T20 /

M17 / M20 / M30 machines.

Please follow step-by-step instructions.

SPECIAL TOOLS / CONSIDERATIONS: NONE

(Estimated time to complete: 30 minutes)

PROTECT THE ENVIRONMENT

Please dispose of packaging mat erials , used machine component s

such as bat t er ies and f luids in an envir onment ally saf e way according

to local was t e disposal regulat ions.

Always remember to recycle.

PREPARATIO N:

1. T urn on the machine, completely raise the

rear squeegee from the floor, turn off the

machine, set the parking brake, and remove

the key.

FOR SAFETY: Before leaving or servicing

machine, stop on level surface, turn off

machine, set parking brake, and remove key.

2. Disconnect the vacuum hose from the

squeegee assembly and remove the

squeegee assembly from the machine. Set

the squeegee assembly and all mounting

hardware aside.

INSTALLATION:

1. Remove the existing rear squeegee wheel

assembly from the machine. Discard the

existing rear squeegee wheel assembly and

hardware. (Fig. 1)

2. Use the hardware provided with the new rear

squeegee wheel assembly (1) to install the

rear squeegee wheel assembly onto the

squeegee caster pivot. Be sure there is no

side to side movement of the rear squeegee

wheel assembly in the squeegee caster pivot.

Also be sure the rear squeegee wheel

assembly spins freely in the squeegee caster

pivot. (Fig. 1)

3. Connect the grease gun to the rear squeegee

wheel assembly (1) zerk and pump the grease

gun two times to apply grease into the rear

squeegee wheel assembly. (Fig. 1).

4. Reinstall the rear squeegee assembly onto

the machine and reconnect the vacuum hose

to the rear squeegee assembly.

Summary of content (2 pages)

PAGE 1
INSTRUCTION BULLETIN No. 9014333 Machine: M17 / T17 / M20 / T20 / M30 Published: 09- 2016 Rev. 00 NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts List in the appropriate place in the machine manual for future reference. Retaining the Parts List will make it easier to reorder individual parts and will save the cost of ordering an entire kit. NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
PAGE 2
M17 / T17 Machines Squeegee frontcoupling FRONT Do not remove squeegee caster pivot to install rear squeegee wheel assembly (1). Rear squeegee caster assembly shown removed to better show part part locations. Replace existing rear squeegee wheel assembly with new rear squeegee wheel assembly (1) * Squeegee lift cross member FRONT Caster pivot Do not remove squeegee caster pivot to install rear squeegee wheel assembly (1). Rear squeegee caster assembly shown removed to better show part part locations.