Convert Off-Board Charger From 480 vac To 400 vac

IB 9016098 (12- 2017) 1

INSTRUCTION BULLETIN

No. 9016098

Machine: M17 / T17

Published: 12- 2017

Rev. 00

NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the

Parts List in the appropriate place in the machine manual for future

reference. Retaining the Parts List will make it easier to reorder

individual p arts and will save th e cost of ordering an entire kit.

NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.

Installation instructions for kit number 9016099

SYNOPSIS:

This kit contains instructions to convert the 36VDC/160A off board charger from 480 vac to 400 vac

for M17 / T17 machines.

Please follow step-by-step instructions.

SPECIAL TOOLS / CONSIDERATIONS: NONE

(Estimated time to complete: 15 minutes)

PROTECT THE ENVIRONMENT

Please dispose of packaging mat erials , used machine component s

such as bat t er ies and f luids in an envir onment ally saf e way according

to local was t e disposal regulat ions.

Always remember to recycle.

1. Press and hold the Enter / Power button on

the battery charger to power it up.

2. Press and hold the ESC (Escape) button to

enter the screen.

PAGE 1
INSTRUCTION BULLETIN No. 9016098 Machine: M17 / T17 Published: 12- 2017 Rev. 00 NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts List in the appropriate place in the machine manual for future reference. Retaining the Parts List will make it easier to reorder individual parts and will save the cost of ordering an entire kit. NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
PAGE 2
3. Press the four outer buttons as needed to navigate through screens in the following steps. 6. Navigate to “Power Supply” then Enter. 7. Select “400VAC” then Enter. 4. Navigate to “Password” then press the Enter/Power button. Enter the password 0 0 9 9 then Enter. 8. Press the ESC button to verify the correct setting was selected. An asterisk (*) will show next to active setting (*400VAC). 5. Navigate to “Settings” then Enter. 9. Press ESC then navigate to the “Exit” setting and select it. 10.