Installation Instructions

5. After inserting the
batteries, wait a few
seconds and the TELUS
remote will be ready to
operate the Set-Top-Box.
TELUS
remote control
Take Off Guide
1. TELUS
Remote Control
2. Turn On TELUS RCU
1. Turn ON your TV and your
Set Top Box.
2. Remove your TELUS
remote control and its
batteries from the plastic
bag.
3. Remove the remote’s
battery lid.
4. Place the batteries on the
TELUS remote control as
indicated in the image
above and replace the
battery lid.
. Reorient or relocate the receiving antenna.
Risk of explosion if the battery is replaced
by an incorrect type, disposal of a battery
into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can
result in an explosion;
Leaving a battery in an extremely high
temperature surrounding environment that
can result in an explosion or the leakage of
flammable liquid or gas;
A battery subjected to extremely low air
pressure that may result in an explosion or
the leakage of flammable liquid or gas.
TELUS remote control arrives with a 2 AAA batteries blister.
To turn on your TELUS remote control, please follow the
instructions below.
CAUTIONFCC Compliance Statements
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or televison reception,
which can be determinated by turning the
equipment off an on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
. Increase the separation between the
equipment and receiver.
. Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
.Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC
radiation expuser limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.
Warning: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.