CPE8100 Outdoor CPE Quick installation guide V1.
PLEASE READ THESE SAFETY PRECAUTIONS! RF Energy Health Hazard The radio equipment described in this guide uses radio frequency transmitters. Although the power level is low, the concentrated energy from a directional antenna may pose a health hazard. Do not allow people to come in close proximity to the front of the antenna while the transmitter is operating.
• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 , Subpart E of the FCC Rules.
Table of Contents 1. OVERVIEW ................................................................................................................................................ 5 2. USER INTERFACE SPECIFICATION ..................................................................................................... 5 GETTING STARTED................................................................................................................................ 5 DEVICE LOGIC CONNECTION .....................
1. Overview CPE8100 is a high performance LTE CPE (Customer Premises Equipment) product designed to enable quick LTE service deployment to the remote customers. It provides high data throughput and networking features to end users who need both bandwidth and roaming capabilities in the certain area. User Interface Specification Model Description & User Interface - Panel antenna: B42_43 14dBi - 1 RJ45 10/100/1000M LAN Port - PWR, RUN, LAN, SIM, and LTE (1-6) LEDs CPE8100 - 48V/0.
3) Installing the Equipment Device Logic connection For outdoor CPE product, it is suggested that the CPE device be installed in a shaded area to avoid direct sun light exposure which may cause over heat in certain extreme weather condition. The CPE should be properly grounded for proper protection against lighting or power surge. To power on the device, the outdoor CPE must use a 48V PoE integrated DC power supply adapter.
Installing Outdoor Unit (ODU) – Pole Mount Installing Outdoor Unit (ODU) – Wall Mount Note: The wall screws and screw anchors are not part of the package. Recommended screw size minimum 50mm length and 6-8mm diameter.
Header Connection: Grounding Make sure that the installation of the outdoor unit, antenna and cables is performed in accordance with all relevant national and local building and safety codes. Even where grounding is not mandatory according to applicable regulation and national codes, it is highly recommended to ensure that the outdoor unit and the antenna mast are grounded and suitable lightning protection devices are used so as to provide protection against voltage surges and static charges.
Connect one of a grounding cable to the grounding screw and firmly tighten the grounding screw. Connect the opposite end of the grounding cable to a good ground(earth) connection.
3 Managing CPE Device CPE8100 is a user-friendly LTE CPE, and very easy to configure and setup. Subscribers can just connect the device to their computer or home switch/router and the device is ready to provide Internet Services. WEB Login It is a preferred to setup the CPE using a Web browser from a local PC connected to device LAN port. The user should ensure that the connected PC have acquired IP address via DHCP from the device.
Device Status Once the user is logged in, the following window device status window will be prompted for viewing. It contains both the system information, networking and device information configured for the device. For further configuration instructions, please refer to CPE8100 user manual. 4 FAQ and Troubleshooting 1) My PC cannot connect to the CPE. Re-plug the PC Ethernet cable and check if the PC LAN connection is up or showing activity. Check if the PoE power adapter LED is on.
First check if the NIC is up and working properly. Then check the PC NIC configuration and make sure the DHCP is enabled. Open the MS-DOS window, enter “ipconfig /release” and “ipconfig /renew” commands and see if PC can obtain IP correctly. If the problem persists, please contact the operator or distributor for further diagnose. 3) My CPE networking is not working properly. You may want to check if the LTE connection is up and running properly.
