Quick Start Guide

TE590P
Quick Start Guide
Power Button/Channel Switch
Emergency Button
GPS Antenna
Led Indicator
Receiver
Programmable Button
PTT Button
Touch Screen
Volume Button
Back
Home
Menu
Speaker
Sling Hole
Rear Camera
Flash
Accessory Connector
USB-C/Charger
Camera Button
Charger Docking Port
Battery Lock
Before Use
Charging
Cautions
Although your device is quite sturdy, it is a complex piece of
equipment and can be broken. Avoid dropping, hitting or bending,
or sitting on it.
Telo Systems
Tel: [phone]
E-mail: [e-mail]
Add:6/F, No.42 Liuxian 1st Road,
Bao'an District, Shenzhen, China
www.telosystems.com
4. Pull the“ ” if there Battery Lock
be a need to uninstall the battery.
1. Remove the SIM cover . Then insert
the SIM/TF card into its slot. Attach
the SIM cover and tighten the set screw.
2. Put back and push to lock the battery.
3.Press and hold the power button
until the screen lights up to turn on
the device. Press the power button
to put the device screen to sleep,
press again to wake it up.
Operating State
Indication
Standby
Green (Blinking)
Searching Network
Green (Fast Blinking)
Low Battery
Red(Blinking)
Charging
Red(Steady)
PTT Transmitting
Red(Steady)
PTT Receiving
Green(Steady)
Battery Tips
Battery charging indicator
Led Indicator Battery Status
Red(Steady) Recharging
Green(Steady) Charged full
Note
Check List
TE590P×1
Battery×1
Belt Clip×1
Travel Charger×1
USB-C Cable×1
Desktop Charger×1
Quick Start Guide×1
Thanks for choosing our product!
This Quick Start Guide Only applicable to: TE590P.
Before using the product, please read the Quick Start Guide to fully
benefit from it.
Notice:
Please check the following accessories before you discard the packing
material. Please contact your local dealer immediately if there is any
missing or damage parts.
Warranty period is 1 year from date of purchase.
This product involves constant upgrading and/or improvement, our
company reserves the right to change the specifications of software
and/or hardware mentioned in this operating guide without any prior
notice. The product specifications and information mentioned in the
operating guide are for reference only.
Using USB-C Cable
Using Desktop Charger
Make sure the charger/USB port, microSD card/SIM card lot covers are
properly seated, with no foreign objects obstructing the seals.
Do not use the charger/USB port for charging, data transmission, etc.
until the phone is completely dry.
Do not store the device under any circumstance containing electronic
erosive material.
Avoid to pull the device up by holding the antenna or accessories.
Please power off and unload the battery before cleaning the device.
Using dry and clean lint-free cloth or hairbrush to keep the device and
charger docking port clean.
Avoid to use any chemical agent including detergent, alcohol, aerosol
spay or oil preparations as cleaning solution.
Dry your device completely after cleaning and before using it again.
Always use Telo Original batteries and chargers. The warranty does
not cover damage caused by non-Telo batteries and/or chargers.
Avoid using the device while charging it.
Do not use the above two charging methods simultaneously.
FCC Statement
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipmen
WiFi 5G does not support hotspot.t.
15.105 Information to user.
This equipment has been tes
ted and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference t
o radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This product meets the government's requi
rements for exposure to
radio waves. The guidelines are based on standards that were
developed by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons
regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6 W/kg averaged over one gram of tissue. This device was tested for typ-
ical body-worn operations when the device used at 25mm from front face
and 10mm from the product, 0mm from th
e belt, for maintain compliance
with FCC RF exposure requirements. The use of belt clips, holsters and si-
milar accessories should not contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements may not com-
ply with FCC RF exposure requirements, and should be avoided.
RED Statement
1. Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
2. The product shall only be connected to a USB interface of version
USB2.0 or higher.
3. Adapter shall be installed near the equipment and shall be easily
accessible.
4. The operating temperature of the EUT can’t exceed 45℃ and shouldn’t
be lower than -10℃.
5. The plug considered as disconnect device of adapter.
6. The device complies with RF specifications when the device used at
25mm from front faceand 5mm from the product, 0mm from the belt.
7. U
se careful with the earphone maybe possible excessive sound pressure
from earphones and headphones can cause hearing loss.
Hereby, Telo Systems Ltd. declares that this Mobile phone product is in
compliance with essential requirements and other relevant provisions of
Directive 2014/53/EU. This product is allowed to be used in all EU member
states.
Only indoor use for band 5150-5350MHz.