User's Manual

ManualsBrandsTelnova Technology ManualsElectronicsBLUETOOTH MODULE

Telnova Technology Co.,Ltd

This module is limited to OEM installation ONLY

Bluetooth Module for Audio Application

F-3066 Class2 Bluetooth Module

Features

. Bluetooth V2.1+EDR specification support

. A2DPv1.2

. AVRCPv1.0

. HFPV1.5

Applications

. This module applies only to the following Bluetooth speaker:

Manufacturer : Telnova Technology Co.,Ltd

Producted name: Bluetooth Spesaker

Model name:MBT

300

Brand name:N/A

Block Diagram

This is part circuit structure: The encoder IC IS1681S(OSC16MHz), it is a single chip radio and

basedand is for Bluetooth 2.4GHz systems including enhanced data rates(EDR) to 3MBPS; The

EEPROM 24C32, it is a single chip 8 megabit(1024X8-bit-/512kx16-bit) Flash memoy, CMos

3.0 Volt-only. The module Supports Bluetooth v2.1. the Frequency range: 2402-2480MHz. The

module also has necessary balun and bandpass filters to interface with a build-in PCB antenna,

which forms a very cost effective radio subsystem.

IS1681S

Summary of content (9 pages)

PAGE 1
Telnova Technology Co.,Ltd This module is limited to OEM installation ONLY Bluetooth Module for Audio Application F-3066 Class2 Bluetooth Module Features . Bluetooth V2.1+EDR specification support . A2DPv1.2 . AVRCPv1.0 . HFPV1.5 Applications . This module applies only to the following Bluetooth speaker: Manufacturer : Telnova Technology Co.
PAGE 2
Telnova Technology Co.
PAGE 3
Telnova Technology Co.
PAGE 4
Telnova Technology Co.
PAGE 5
Telnova Technology Co.,Ltd Notes: 1 PSR configuration setting maintains the transmit power to be within the Bluetooth specification v2.0 limits 2 Class 2 RF transmit power range, Bluetooth specification v2.0 3 Up to five exceptions are allowed in v2.0 of the Bluetooth specification 4 Up to three exceptions are allowed in v2.0 of the Bluetooth specification 5 Measured at F0 = 2441MHz Installation diagram Module Installation location(Telnova Technology Co.
PAGE 6
Telnova Technology Co.,Ltd FCC Statement: NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by ValenceTech Limited may void the FCC authorization to operate this equipment.
PAGE 7
Telnova Technology Co.,Ltd Note: If this module is intended for use in a portable device, you are responsible for separate approval to satisfy the SAR requirements of FCC Part 2.1093. Please be noticed following information and instructions should be placed in the end-user’s operating manual The F-3066 Module has been granted as limited modular approval for BLUETOOTH SPEAKER. F-3066 Module must be installed in the designated host as specified in this manual. 1.
PAGE 8
Telnova Technology Co.,Ltd demonstrated to regulations for other transmitter components within the host product; to requirements for unintentional radiators (Part 15B). To ensure compliance with all non-transmitter functions the host manufacturer is responsible for ensuring compliance with the module(s) installed and fully operational.
PAGE 9
Telnova Technology Co.,Ltd If this module is intended for use in a portable device, you are responsible for separate approval to satisfy the SAR requirements of FCC Part 2.1093.