EcoView/EcoContact Installation Guide PST6200/PST6250 Company Headquarters: Telkonet, Inc. 10200 W. Innovation Dr. Suite 300 Milwaukee, WI 53226 Support Information: (800) 380 9640 ecosmartsupport@telkonet.com Sales Information: (888) 703 9398 sales@telkonet.comsales@telkonet.
Table of Contents Table of Contents .................................................................................................................. i Installation ......................................................................................................................... 1 Required Equipment ........................................................................................................... 1 Hardware ....................................................................................
Installation Required Equipment Hardware EcoView (PST6200) or EcoContact (PST6250) Small Phillips screwdriver Security screw wrench (provided by Telkonet) Two mounting screws Two wall anchors Two AA Batteries Regulatory Compliance This device complies with Part 15 of the FCC Rules.
Installation of the EcoView/EcoContact 1. Review the table below and determine where the EcoView/EcoContact will be mounted. Mounting Consideration Best Practice Orientation and Facing The EcoView/EcoContact can be mounted either horizontally on a ceiling or vertically on a wall. In both orientations, the EcoView/EcoContact should be mounted facing the center of the room to provide the best occupancy detection. Distance to Occupant If the occupants will likely be stationary… (e.g.
Configuration Associating an EcoView/EcoContact with an EcoInsight 1. Verify both the EcoView or EcoContact and the EcoInsight are powered. 2. Press and hold the “Fan” button on the EcoInsight for 10 seconds, then press the “On/Off” button. The Maintenance Menu should appear. 3. Verify the text “Learn” appears in the Maintenance Menu. 4. Press the “On/Off” button to enter the Learn menu.
5. Assign a unique installer number by pushing the up or down arrows. The smaller number on the screen will increase or decrease. 6. Press the “On/Off” button again to activate Learn Mode. The text “On” should appear next to the smaller number. See Figure 3. Figure 3: Maintenance → Learn Menu with 1 Device Associated, In Learn Mode 7. Using the paperclip, press the pushbutton inside the EcoView’s/EcoContact’s pinhole once. 8.
Associating an EcoView/EcoContact with an EcoSource 1. Verify the EcoView or EcoContact, the EcoSource, and the EcoAir are powered. 2. Press and hold the “Fan” button on the EcoAir for 10 seconds, then press the “On/Off” button. The Maintenance Menu should appear. 3. Verify the text “Learn” appears in the Maintenance Menu. 4. Press the “On/Off” button to enter the Learn menu. Two numbers will appear in the center of the screen. See Figure 4. Figure 4: Maintenance → Learn Menu with 1 Device Associated 5.
7. Using the paperclip, press the pushbutton inside the EcoView’s/EcoContact’s pinhole once. 8. Verify the front of the EcoView/EcoContact blinks a number of times equal to the unique installer number you chose in step 5. 9. Verify the larger number in the EcoAir “Learn” menu has increased by one. 10. Press the Fan button on the EcoAir twice to exit out of the Maintenance Menu. 11. Association is complete. EcoView/EcoContact Installation Guide Configuration Revision 1 Page 6 Telkonet, Inc. 10200 W.