3222 Phoenixville Pike, Suite 200 Malvern, Pennsylvania TEL: 1 610 430 2700 ALIO Note Installation and User Guide 1|Page
Contents: Page Introduction……………………………………………………………………………………3 Specifications………………………………………………………………………………….3 Part List…………………………………………………………………………………………..3 Warnings………………………………………………………………………………………..3 Cleaning………………………………………………………………………………………….3 Installation…………………………………………………………………………………..4-8 Operation……………………………………………………………………………………….8 Diagnostics……………………………………………………………………………………..9 LEDs Status……………………………………………………………………………………..
INTRODUCTION: ALIO Note is the next generation cashless and telemetry system from CPI that combines a telemeter, antenna, card reader and a full color display into a single device. Specifications: Input Voltage Input Current Operating Temperature Dimensions (bezel) Weight (bezel & Hub) 20-42 VDC Max – 1 Amp (-15°) - +60°C 160mm x 80mm x 40mm 379 Grams (0.83 Lbs.
INSTALLATION: Step 1 2 3 Turn off power to the vend- ing machine Remove the existing bill validator Remove the existing telemeter Process Unscrew the four hex nuts from the mounting posts with the 11/32 nut driver, and disconnect any cabling. Disconnect all connections to the telemeter and remove the antenna from the top of the vendor. Because ALIO Note’s antenna is contained within the bezel, there is no need to run an antenna through the top of the machine.
INSTALLATION CONTINUED: 5|Page
INSTALLATION CONTINUED: 6|Page
INSTALLATION CONTINUED: 7|Page
INSTALLATION CONTINUED: OPERATION: ALIO Note is fully configured for operation from the factory and once mechanically installed onto Talos bill validator and powered it will connect to the cellular network ready for use. Detailed information of connection status can be viewed by pressing the red “X” on the ALIO Note display 5 times. The display will reconfigure to indicate the status. Once connected, “Please Tap or Swipe Card” will be displayed and the ALIO Note is ready to accept cards for transactions.
DIAGNOSTICS: Once ALIO is installed, you can perform basic diagnostics on the device by pressing or holding the large button in the center of ALIO Hub: LEDS STATUS: ALIO Hub has an LED ring around the CPI logo that will change colors, depending on the current state of ALIO.
TROUBLESHOOTING: Hold ALIO Hub button for three seconds to access the driver menu, then scroll to the alarm section to view recent issues. The steps below will also help to confirm proper installation. Before Installation 1. Confirm the Asset or Equipment Number and make sure you are at the correct machine After Installation 1. Confirm the vending machine firmware is approved by CPI and matches the asset assigned in the vendor system 2.
this reason, FDA helped develop a detailed test method to measure EMI of implanted cardiac pacemakers and defibrillators from cell phones. This test method is now part of a standard sponsored by the Association for the Advancement of Medical Instrumentation (AAMI). This standard will allow manufacturers to ensure that cardiac pacemakers and defibrillators are safe from cell phone EMI. The FDA continues to monitor the use of cell phones for possible interactions with other medical devices.