Telink Debug EVK TLSR8278DK48D User Manual Features; Pin connection; User manual Brief: This is a user manual for Telink 8278 Dongle.
Telink Debug EVK TLSR8278DK48D User Manual Published by Telink Semiconductor Bldg 3, 1500 Zuchongzhi Rd, Zhangjiang Hi-Tech Park, Shanghai, China © Telink Semiconductor All Right Reserved Legal Disclaimer This document is provided as-is. Telink Semiconductor reserves the right to make improvements without further notice to this document or any products herein. This document may contain technical inaccuracies or typographical errors.
Telink Debug EVK TLSR8278DK48D User Manual Table of contents 1 Product Introduction .............................................................................................. 3 1.1 General description.......................................................................................... 3 1.2 Key features ..................................................................................................... 3 2 Pin Connection Guide .....................................................................
Telink Debug EVK TLSR8278DK48D User Manual 1 Product Introduction This is a user manual for Telink Debug EVK TLSR8278DK48D. 1.1 General description The TLSR8278DK48D, which is based on Telink TLSR8278F1KET48 chip, provides a Bluetooth LE .
Telink Debug EVK TLSR8278DK48D User Manual connect the GND to the GND of J18.
Telink Debug EVK TLSR8278DK48D User Manual 2.2 Download firmware To download firmware into TLSR8278DK48D, first make sure the TLSR8278DK48D is supplied with power normally. That is, connect the power to the 3V3 of J18, and connect the GND to the GND of J18. Then connect J18 (SWS) of the TLSR8278DK48D with SWM of a burning EVK. Meanwhile, connect the miniUSB interface of the burning EVK with PC USB.
Telink Debug EVK TLSR8278DK48D User Manual 2.3 Test RF signal To test RF signal of TLSR8278DK48D, first make sure the TLSR8278DK48D is supplied with power normally. That is, connect the power to the 3V3 of J18, and connect the GND to the GND of J18. In conducted mode, connect SMA connector to spectrum analyzer, or other RF instruments. In radiated mode, connect SMA connector to external antenna.