User's Manual

TT5800 Quick User Guide

802.11a 310mW

Package Contains

1. TT5800 802.11a PCBA (1)

2. IEEE 802.11a miniPCI radio card (1)

3. Power over Ethernet Injector (1)

4. 48VDC Power Adapter (1)

5. Ethernet Cable (2)

6. Waterproof RJ-45 Connector (1)

7. Mounting Hardware (1)

8. 23dBi Subscriber antenna,

9. 20cm RF cable (cable loss: 8dB)

10. User Manual

Quick Installation

Always double check for any missing parts from the kit you received before deployment.

Next step is to set up the computer Ethernet interface for configuring the TT5800. Since the default IP Address of the

unit is on the 192.168.10.x IP range in both Client Bridge and AP mode you’ll need to set the computer Ethernet

interface within the same IP range, such as 192.168.10.66.

Hardware Installation

Follow the procedure below to install your TT5800 device:

1. Select a suitable place on the network to install the TT5800. For best wireless reception and performance the

external antenna should be positioned within Line of Sight from the AP with proper alignment.

2. Connect the TT5800 to the ODU side of the PoE Injector via a straight Ethernet cable (Cat-5), then connect the

NET side of the PoE Injector to either a computer or an Ethernet Switch.

Note: The TT5800 now fully supports the MDI/MDI-X standard and no longer require the use of cross over cable to

connect directly with a computer.

3. Connect the 48VDC power adapter to the power jack on the PoE injector to power on the TT5800.

Check the LEDs on the TT5800 to confirm if the status is okay. At this point the PWR and LAN LEDs should be on

green. The WLAN light should light up once the unit is associated wirelessly with another wireless device. However

at this point the unit is still in factory default setting so do not the alarmed that the WLAN light doesn’t light up.

PAGE 1
TT5800 Quick User Guide 802.11a 310mW Package Contains 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. TT5800 802.11a PCBA (1) IEEE 802.11a miniPCI radio card (1) Power over Ethernet Injector (1) 48VDC Power Adapter (1) Ethernet Cable (2) Waterproof RJ-45 Connector (1) Mounting Hardware (1) 23dBi Subscriber antenna, 20cm RF cable (cable loss: 8dB) User Manual Quick Installation Always double check for any missing parts from the kit you received before deployment.
PAGE 2
Web Control Interface Default IP Address in Client Bridge Mode: 192.168.10.241 Default IP Address in Access Point Mode: 192.168.10.240 Default Login / Password: Nothing needs to be typed in for login and password authentication. For detailed instructions on how to configure the TT-5800, please refer to www.teletronics.com/Support.html TT5800 is current designed to be configured only for the point-to-point operation mode, one access point (AP)and one access client (AC) are needed.
PAGE 3
RMA Policy Product Return Policy It is important to us that all Teletronics’ products are bought with full confidence. If you are not 100% satisfied with any product purchased from Teletronics you may receive a prompt replacement or refund, subject to the terms and conditions outlined below. IMPORTANT: Before returning any item for credit or under warranty repair, you must obtain a Return Merchandise Authorization (RMA) number by filling out the RMA form. Products will not be accepted without an RMA number.