Subject: User Manual for the US Telecell Date: 18 May 2010 Document ref: LLT173 01 Intentionally Blank LLT173 01 QP4016 07- Tech Note Template 18 May 2010 Page 1 of 9
Contents OPERATIONAL SAFETY NOTICES............................................................................................................... 3 FCC STATEMENT ............................................................................................................................................ 3 1 SPECIFICATIONS .................................................................................................................................... 4 1.1 MULTI-VOLT TELECELLS ............................
Operational Safety Notices The radio equipment described in this guide emits radio frequency energy. Although the power level is low, the concentrated energy from a directional antenna may pose a health hazard. Only outdoor antennas certified with this transmitter should be used and must be installed to provide a separation distance of at least 20 cm from all persons. More information on RF exposure is available on the Internet at www.fcc.gov/oet/info/documents/bulletins.
1 Specifications 1.1 Multi-volt Telecells 1.1.1 • Electrical Parameters: Supply voltage: 102 - 276 VAC, 60Hz (multi-volt variants) 408 – 552 VAC, 60Hz (480V variants) • 1.1.2 • Maximum switching current: 10A Radio: Transmit Power: 100mW EIRP. 1.1.3 Operating Temperature: • NEMA & Conduit variants: -40 to 60 °C (Ambient) 2 Telecell The Telecell contains a radio control processor, lighting control and monitoring circuitry, together with an electricity meter.
3 Telecell Variants A full product breakdown is given in the following table: Type Description TC-A2-NM-XX-E NEMA Telecell, blue, multi-volt (120/240 VAC), dimming-compatible. TC-A2-NM-XX-N NEMA Telecell, blue, multi-volt (120/240 VAC), nondimming. TC-A3-NM-XX-N NEMA Telecell, yellow, 480V, non-dimming. TC-A2-CN-XX-E Conduit Telecell, blue, multi-volt (120/240 VAC), dimming-compatible. TC-A3-CN-XX-N Conduit Telecell, yellow, 480V, non-dimming.
5 Installation Instructions Instructions for the installation of each of the different variants of Telecell are given below. Figure 1 shows a wiring diagram for a standard lamp with a non-dimmable ballast. Figure 2 shows the case where there is a dimmable ballast and a dimming control module (TDM-A) is included. 5.1 NEMA Telecell Insert unit into NEMA socket on street light ensuring the largest tab on the unit places into the largest tab on the NEMA receptacle on the street light.
Figure 1: Wiring Diagram for Telecell (No Dimming Module) LLT173 01 QP4016 07- Tech Note Template 18 May 2010 Page 7 of 9
Figure 2: Wiring Diagram for Telecell (With Dimming Module) LLT173 01 QP4016 07- Tech Note Template 18 May 2010 Page 8 of 9
6 Contact Details Mail Address: Telensa Ltd, Plextek Building, London Road, Great Chesterford, Essex, CB10 1NY. UK. Telephone: +44 (0) 1799 533200 Fax: +44 (0) 1799 533201 Email: enquiries@telensa.com Website: http://www.telensa.
