User's Manual

ManualsBrandsTelematics Wireless ManualsElectronicsDual Frequency Hand Held Reader

REV.

∆

DESCRIPTION E.C.N. DATE DRAWN CHECKED

A 086 22/01/05

B According to FCC remarks

C FCC remarks 4/26/2005

D FCC remarks 5/25/2005

PROPRIETARY INFORMATION

ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED, STORD IN

RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC,

MECHANICAL PHOTOCOPYING, RECORDING OR OTHERWISE WITHOUT THE PRIOR WRITTEN

PERMISSION OF TELEMATICS WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY

PURPOSE OR FOR ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.

DESIGNED G.F.K. 10-Feb-2005 SHEET/OF

CHECKED Y.S. 14-Feb-2005

APPROVED M.N. 14-Feb-2005

NAME:

TDMA Reader-FP200HH

User Manual

Q.A. A.S. 15-Feb-2005

PROD/PROJ: HANDHELD READER

SIZE

Summary of content (8 pages)

PAGE 1
REV. ∆ DESCRIPTION A B According to FCC remarks C FCC remarks 4/26/2005 D FCC remarks 5/25/2005 E.C.N. DATE 086 22/01/05 DRAWN CHECKED PROPRIETARY INFORMATION ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED, STORD IN RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC, MECHANICAL PHOTOCOPYING, RECORDING OR OTHERWISE WITHOUT THE PRIOR WRITTEN PERMISSION OF TELEMATICS WIRELESS LTD.
PAGE 2
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. WARNING! Changes or modifications to this unit not expressly approved by Telematics Wireless Ltd. could void the user's authority to operate the equipment.
PAGE 3
FP200HH User Manual Table Of Contents 1. 2. GENERAL INFORMATION ...............................................................................................4 1.1 INTRODUCTION.............................................................................................................................. 4 1.2 PURPOSE ........................................................................................................................................ 4 1.3 PREPARATION................................
PAGE 4
FP200HH User Manual 1. General Information 1.1 Introduction The Handheld Reader (HH Reader) is a dual frequency, TDMA reader to be used in mobile application where the lightweight and friendly user interface is mandatory. The HH Reader provides information access and setting for Telematics-Wireless electronic seals and transponders. Note: Everywhere 2.4 GHz is mentioned, the actual real frequency is 2.44 GHz. 1.
PAGE 5
FP200HH User Manual 2. CONTROLS and INDICATORS 2.1 TDMA Reader The ON/OFF switch of HH Reader is the ON/OFF switch of the iPAQ. After turning the unit ON, the iPAQ will display the same display as before turning it OFF. If the system window shown in Fig.1 appears, push the right upp er switch, Fig.2, of the iPAQ lower part and get Fig.3 application screen. ON/OFF switch Application switch Fig. 1: System screen Fig. 2: Application swich Select “Enter” and get “Tag Search” screen – Fig.
PAGE 6
FP200HH User Manual Change frequency to 2.4 GHz – Fig.6 Select “Tag search” and get in the list, the tag that is being used in this procedure. – Fig.7 Fig. 6: 2.4 GHz Fig.7: 2.4 GHz Tag list Select “exit” and exit the application to system screen Now you can turn the power OFF.
PAGE 7
FP200HH User Manual 2.2 Charging The HH Reader has a single charger for both the iPAQ and the reader electronic board. The charger connector is located in the HH Reader bottom side. Open the black rubber cover on the bottom side of the HH Reader – See Fig.8. Connect the charger to charger connector of the HH Reader, – See Fig.9. Wait for the power indicator of the iPAQ, see Fig.10, to stop blinking and turn ON constantly. Now the HH Reader is fully charged.
PAGE 8
FP200HH User Manual 2.3 Errors Conditions Error message 2140-72017-00-0A Reason To do TDMA reader is off 1. Exit application Coomunication with TDMA reader lost 2. Turn TDMA reader on 3. Restart application RF interference 1. Make sure within range Reader not pointing seal 2. Hold reader toward seal Seal out of range 3.