User's Manual

ManualsBrandsTelematics Wireless ManualsElectronicsWater meter



_____________________________________________________________________________________



Master Meter, Inc.  101 Regency Pkwy, Mansfield, TX 76063  T: 817-842-8000  F: 817-842-8100  MasterMeter.com





INTERPRETER2

Installation

Instructions



FCCID:NTA3GINTRP2

IC:4732A‐INTRP2

Rev1.0

April24,2016



Summary of content (5 pages)

PAGE 1
_____________________________________________________________________________________ INTERPRETER2 Installation Instructions FCC ID: NTA3GINTRP2 IC: 4732A‐INTRP2 Rev 1.0 April 24, 2016  Master Meter, Inc.  101 Regency Pkwy, Mansfield, TX 76063  T: 817-842-8000  F: 817-842-8100  MasterMeter.
PAGE 2
_____________________________________________________________________________________ CAUTION The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment.
PAGE 3
_____________________________________________________________________________________ The antenna used for this transmitter must be installed to normally provide minimum separation distance of at least 20 cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter. Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de son fonctionnement normal.
PAGE 4
_____________________________________________________________________________________ MULTI‐JET METER INSTALLATION INSTRUCTIONS The installation instructions detailed below are consistent with recommendations by the American Water Works Association in AWWA Manual M6, Water Meters‐Selection, Installation, Testing, and Maintenance. WE RECOMMEND IN THE DESIGN OF THE INSTALLATION: 1.
PAGE 5
_____________________________________________________________________________________ AT THE TIME OF INSTALLATION: 1. Thoroughly flush the service line upstream of the meter to remove dirt and debris. 2. Remove meter spud thread protectors. Note: To protect the meter spud threads, sore the meter with the thread protectors in place. 3. Set the meter in the line. Arrows on the side of the meter and above the outlet spud indicate the direction of flow. 4.