User Manual

ManualsBrandsTelemann ManualsElectronicsDTR5000N

Hardware Description

Here, you will be given the explanation of the front and rear panel of DTR5000N. Each of

display, ports, connections will be specifically explained.

Front Panel Configuration

1 LED DISPLAY

This shows the channel number or other information as follows :

During power is off, the dash ‘-‘ will be displayed at each digit, which

indicates that your DTR5000N is in stand-by mode. Immediately after your

decoder turns on, ‘C . . .’ will in turn light up at each digit, which means that

your DTR5000N is ready to operate.

If your DTR5000N locks a channel, its channel number will be displayed.

Whenever you change the channel, the number of the changed channel will be

displayed.

2 REMOTE SENSOR

It receives the infrared signal from Remote Control and operates your

DTR5000N.

3 



 Smart Card and/or PCMCIA Card Slot (Option), or Not Used

These two slots can be used either for Conditional Access System with Smart

card, or Common Interface Module with PCMCIA card, or may not be used at

Summary of content (5 pages)

PAGE 1
Hardware Description Here, you will be given the explanation of the front and rear panel of DTR5000N. Each of display, ports, connections will be specifically explained. Front Panel Configuration 1 LED DISPLAY This shows the channel number or other information as follows : During power is off, the dash ‘-‘ will be displayed at each digit, which indicates that your DTR5000N is in stand-by mode. Immediately after your decoder turns on, ‘C . . .
PAGE 2
DTR5000N Hardware Description all in case of free-to-air only according to the option configuration of the DTR5000N. When you want to watch Pay-per-view TV program or enjoy Internet service on a usage basis, you should purchase a smart card or PCMCIA card from the service provider and insert it into this slot. The detailed usage explanation will come with the card that you purchased. 5 CHANNEL DOWN You can sequentially select the previous service by pressing this DOWN key.
PAGE 3
DTR5000N Hardware Description broadcast service and telnet monitor. 6 VIDEO output terminal Connect this terminal to video input terminal of TV or VCR. 7 AUDIO L/R output terminals Connect these terminals to audio L/R input terminals of TV, VCR, or Hi-Fi audio system. 8 S-VIDEO output terminal This terminal is connected to S-VIDEO input terminal of TV or VCR to output S-VIDEO signal. 9 VCR SCART connector Connect this connector to that of VCR via a SCART cable.
PAGE 4
DTR5000N Hardware Description Connection of your DTR5000N to a TV set Connect your DTR5000N to a TV set with SCART. Connection of your DTR5000N to a VCR Connect the SCART connector of VCR to that on your DTR5000N. Connection of your DTR5000N to a Hi Fi system Connect a RCA/Cinch stereo cable from the AUDIO L/R terminals on your DTR5000N to the LINE, AUX, SPARE or EXTRA input terminals on your Hi Fi system.
PAGE 5
DTR5000N Hardware Description