User Manual

ManualsBrandsTelemann ManualsElectronicsDTR5000N

RADIO FREQUCNCY INTERFERENCE STATEMENT

Note : This equipment has been tested and found to comply with the limits for a Class B

Digital device, pursuant to part 15, Subpart B of the FCC Rules. This equipment generates,

Uses, and can radiate radio frequency energy. If not installed and used in accordance with

The instructions, it may cause interference to radio communications.

The limits are designed to provide reasonable protection against such interference in a

Residential situation. However, there is no guarantee that interference will not occur in a

Particular installation. If this equipment does cause interference to radio or television

Reception, which can be determined by turning the equipment on and off, the user is

Encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna of the

affected radio or television.

 Increase the separation between the equipment and

the affected receiver.

 Connect the equipment and the affected receiver to

power outlets on separate circuits.

 Consult the dealer or an experienced radio/TV

technician for help.

Summary of content (7 pages)

PAGE 1
RADIO FREQUCNCY INTERFERENCE STATEMENT Note : This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15, Subpart B of the FCC Rules. This equipment generates, Uses, and can radiate radio frequency energy. If not installed and used in accordance with The instructions, it may cause interference to radio communications. The limits are designed to provide reasonable protection against such interference in a Residential situation.
PAGE 2
DTR5000N Safety Precautions SAFETY CAUTIONS This IRD has been manufactured to meet international safety standards. Please read carefully the following safety precautions before you handle the IRD. MAINS SUPPLY LOCATION CLEANING OVERLOADING VENTILATION LIQUIDS SAMILL OBJECTD ATTACHMENTS CONDITIONAL ACCESS and/or COMMON INTERFACE MODULE CONNECTION TO THE SATELLITE DISH LNB EARTHING LIGHTNING SERVICING Use only 85-265V AC 50/60Hz.
PAGE 3
DTR5000N Safety Precautions
PAGE 4
DTR5000N Safety Precautions Introduction About This Manual This manual describes how to install and operate the Model DTR5000N. Only qualified personnel should handle any problems beyond this manual. General Description The DTR5000N is a high-performance IRD (Integrated Receiver Decoder). DTR5000N is fully compliant with the MPEG2 based DVB transmission standards for in-home reception of satellite digital broadcast services such as digital TVs, radio channels, and data.
PAGE 5
DTR5000N Safety Precautions 45Mbps 45Mbps Internet IP IP Video Content, Audio Content Video + Audio DVB/MPEG2 DVB/MPEG2 QPSK Modulator DTR5000N A/V Encoder Video Source Audio Encoder M Audio Source LAN port DTR5000N U IP-DVB Gateway X TV NMS PSTN NOC Equipment T3 : 45Mbps INTERNET Hub PC Personal User LAN Network application CAS Video/Audio Source Router Dedicated Line T1 : 1.5Mbps Internet Service Provider Teleport Broadcast Facility Fig.
PAGE 6
DTR5000N Safety Precautions Lip-sync Error Correction Function Wide PLL Modulator (CH21-69, PAL-B, G, I, D, K) Useful High Speed System Port for System Diagnostic and Upgrade DiSEqC1.0 LNB Control Software TV/VCR scart connectors Teletext : CCIR/ITU-R Broadcast Teletext System B Smart Card interface for CAS Fully compliant with DVB data broadcasting specification (ETSI 301 192) Simultaneous decoding of up to Max.
PAGE 7
DTR5000N Safety Precautions