User Manual

DTR5000N Remote Control

Data set-up process using DTR5000N menu system

How to get into Menu System from your PC using

Telnet

If you are connected to DTR5000N with a PC on a network, you need to

communicate with DTR5000N by using factory default IP. After installing the

LAN connection or direct connection using Ethernet cable, you can change

the IP address of DTR5000N into the IP that you want by using

“dtr_conn.exe” that manufacturer supplies as follows. For network

connection, please see Fig 2 or 3.

1. Your DTR5000N has a factory default local IP address (192.168.0.1).

2. After connecting your DTR5000N to your PC via LAN network or Ethernet

cable, run Telnet software “dtr_conn.exe” in DOS or UNIX environment

and get connected to the DTR5000N using the IP address of DTR5000N.

Filter Set-up

Network Interface

Main Menu/Installation/

LAN setting/Network Interface

IP filtering

MAC filtering

Edit Data Channel

 Insert filter IP address that was assigned by the ISP.

 In LAN connection,

- Standalone : One PC is connected to DTR5000N via LAN cable

Sub-net mask is not used.

- Network : Multi-users are connected to DTR5000N via LAN network.

Sub-net mask is used to filter IP group

 Insert MAC address that was assigned by ISP.

 Move to Network Interface menu

 Insert local IP address of DTR5000N and Destination IP.

 Destination IP is the IP address that DTR5000N sends

data to.

 When you change IP address, DTR5000N

automatically reboots.

 Select filter type either IP or MAC

 At the Edit Data Channel List, enable the data channel

that you want by selecting ‘Enable’.

You are ready to receive

Internet Data

PAGE 1
DTR5000N Remote Control Data set-up process using DTR5000N menu system Main Menu/Installation/ LAN setting/Network Interface Network Interface Filter Set-up Move to Network Interface menu Insert local IP address of DTR5000N and Destination IP. Destination IP is the IP address that DTR5000N sends data to. When you change IP address, DTR5000N automatically reboots. Select filter type either IP or MAC Insert filter IP address that was assigned by the ISP.
PAGE 2
DTR5000N Remote Control telnet 192.168.0.1 3. Now Telnet will ask for a password. Enter factory default password ( 0, 0, 0, 0 ). Then the Telnet prompt will pop up. Type “menu”. menu 4. Now, the following “Main Menu” will pop up on your PC monitor The menu structure is explained in “Fig 5. Flow chart of menu system”. The explanation of each menu is given in the following chapter “Menu Operation”. Although the background picture is different is different, the structure and explanation are the same.
PAGE 3
DTR5000N Remote Control and also select the number of local IP address of your PC. Click OK. Then following window pops up. Enter the DTR5000N IP address and password (or if you changed the IP address, enter the new one) and click OK. Then “dtr_conn” will automatically transfer the Filter IP and Destination IP to DTR5000N. Now, you can run the web browser and receive the Internet data via Satellite. Your data request will be transferred to your local ISP via the LAN connection.