User's Manual

27
Pre-Dialing
1. With the phone idle, manually enter the telephone number. The maximum pre-dialing
number length is 32 digits, if the number is over 32 digits, it will emit an error tone.
The
telephone number shows in the display.
2. Press the DIAL Soft key (on base only), Spk button, Talk button (handset only), or line
1 or line 2 button to take a line,
or pick up the corded handset (on the base only) and
then the telephone number will be dialed out.
Answering a Call
For cordless handset:
1. Press the Talk button to answer the call in receiver mode,
-OR-
2. Press the Spk button to answer the call in speakerphone mode,
-OR-
3. Press the corresponding LINE Soft key to answer the call in receiver mode.
4. When nished, press end button.
For the base:
1. Pick up the corded handset,
-OR-
2.
Press the speaker button to answer the call in speakerphone mode,
-OR-
3. Press the corresponding line button to answer the call in speakerphone mode,
-OR-
4. Press the headset button on base to answer the call in headset mode.
6. When nished, hang up the corded handset or press Spk button (in speakerphone) or
headset button (in headset mode) or press the
Talk On/Off
button on the cordless headset
NOTE: If you have set the Auto Answer as On in the cordless handset, you can
answer the call directly by picking up this handset from the
charger, without
pressing any buttons.
NOTE: Adjust the volume by pressing the vol (- or +) button during a call.
Switching Between the Speakerphone, Handset and Headset
Mode
Base
To switch to the speakerphone, press speaker button. The speakerphone indicator
illuminates.
Place the corded handset back into the cradle.
To switch to the corded handset, pick up the handset. The speakerphone or corded headset
indicator
will turn off .
5. Press the Talk On/Off button on the cordless headset (only applicable for RCA 25065RE1).
(only applicable
for RCA 25065RE1) to end the call.

Summary of content (26 pages)