Horizon Vision I232-S LTE CPE Quick Start Model:I232 FCC ID:2ADX3I232
Legal Information Copyright Horizon 2017. All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Horizon and its affiliates. Horizon reserves the right to change or modify any information or specification contained in this manual without prior notice and without any liability. Limitation of Liability Due to the nature of wireless communications, transmission, and reception of data can never be guaranteed.
1 Introduction of Router Your router is for indoor use only and multiple devices like computer, landline phone, or external storage device can be connected to the router to access the Internet, make telephone calls, files sharing, and more. Please ensure the 4 external antennas are plugged into the External antenna ports following the indicator below the ports.
Scenario 3: Data service from Ethernet cord and VOLTE voice using a SIM card Appearance 1 2 3 4 5 6 7 8 Internet status indicator WAN/LAN indicator Power indicator WIFI/WPS indicator Signal strength indicator Power Input LAN ports WAN port 9 10 11 12 13 14 15 16 USB port Telephone port Reset button Power button WPS button Standard SIM card slot WiFi External antennas 4G External antennas Important: Router does not support Micro/Nano SIM card or any other non-standard SIM cards.
2 Setup your Router Ensure the 4 external antennas are plugged into the External antenna ports. Insert a standard SIM card firstly as shown in the following diagram and then connect the power adapter to the power input of the router. Press the Power button to turn on the router, and it will search for available mobile networks automatically. To shut down the router, press and hold the power button for approximately 3 seconds.
The following indicators will turn on when the router has successfully connected to a network.
1. Launch the Internet browser, and enter http://192.168.1.1 in the address bar. 2. Enter the password, and log in to the web management page. The default password is admin. You also can refer to the label on the backside of the router for the default IP address and password. It’s strongly suggested to change the default login password of the WebUI to prevent unauthorized users from changing the routers’ settings.
6 VOLTE & CS Domain Voice Call The Horizon router supports both VOLTE and CS domain voice call services. To change the call mode select Settings > Phone and chose the desired option from the dropdown menu. For best results, the “Auto” setting of network mode is recommended. 7 FAQS & Troubleshooting The “Reset” button, located on the back of the unit, is used in rare cases when the Router may function improperly.
purpose in software that came with the device, or a physical “WPS,” “PBC,” or “Security” button on the device itself. 2. Within two minutes, press the WPS button on your Router and hold for two seconds. You can repeat this process for each WPS-enabled device you’d like to add to your network. Connectivity issues Ensure your SIM card is inserted correctly and has an active data plan.
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF HORIZON. THERE ARE NO OTHER WARRANTIES, EXPRESSED OR, EXCEPT AS REQUIRED BY LAW, IMPLIED, INCLUDING THE IMPLIED WARRANTY OR CONDITION OF QUALITY, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE LIMITED IN DURATION TO THE TERM OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
