XPID200 User Manual Accessory List Item Quantity Unit Type-c cable 1 pc Power Adapter 1 pc Battery 1 pc
Illustration of Equipment ①F1 indicator ②F2 ③Volume ⑧F3 ⑨F4 ⑭Receiver ④Reserved Button ⑤USB port ⑩Power Button ⑮Rear Camera ⑯Label ⑪Reserved Button ⑰Flashlight ⑥Blue Led Indicator ⑫Reserved Pogo Pin ⑦Red LED ⑬Front Camera ⑱RFID Reading Area ⑲Battery Cover Locker ⑳Battery Cover ㉑Wrist Strap Locker ㉒Barcode Scan Window ㉓Cradle Pogo Pin Connector Power on/off Instructions Power on: Press and hold the power button in the off state until the device sends out vibration feedback.
Basic Operation Button Description Power button Turn on or turn off or sleeping mode Menu button Pop-up options menu Home button Back to main interface Back button Return to the previous interface Volume button Adjust the volume Reserved button customize functions when developing software Use and Maintenance 1. It is not suitable to use the device or charge the device in an environment where the temperature is too high or too low. 2.
Battery Usage 1. It is forbidden to disassemble the battery cells under any circumstances. 2. It is forbidden to immerse the battery in liquid to prevent moisture. 3. It is forbidden to charge, use or place the battery near heat sources, such as fire, heater, etc., or under high temperature (such as strong sunlight or very hot cars), otherwise it will cause overheating and fire or shorten the life. It is forbidden to directly solder the battery. 4.
Optional Function Instructions 1. QR code Refer to the built-in demo of the device. If the customer needs secondary development, please contact the technical support engineer; the QR code can scan the barcode of the mainstream symbology, but please pay attention to the clarity of the barcode. 2. High frequency (13.56MHz) Refer to the built-in demo of the device, if you need secondary development, please contact the technical support engineer 3. UHF (860-960MHz) Refer to the built-in demo of the device.
4. The operating temperature of the device can’t exceed 45℃ and shouldn’t be lower than -20℃. 5. The plug considered as disconnect device of adapter. 6. The device complies with RF specifications when the device used at 5mm from the body and 0mm from the head. 7. The band 5150-5350MHz indoor use only. Hereby, Shenzhen Handheld-Wireless Co., Ltd. declares that this product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU.