User's Manual

ManualsBrandsTekTone Sound & Signal Mfg ManualsElectronicsWireless call point

WCP-11-TEK User Manual and Specification

Table of Contents

1. Introduction .................................................................................................................................... 1

2. System Overview............................................................................................................................. 2

3. Operation ........................................................................................................................................ 4

4. RF Exposure ..................................................................................................................................... 4

Summary of content (5 pages)

PAGE 1
WCP-11-TEK User Manual and Specification Table of Contents 1. Introduction .................................................................................................................................... 1 2. System Overview............................................................................................................................. 2 3. Operation ........................................................................................................................................
PAGE 2
16 Nov 2022 WPC-11C-TEK User Manual and Specification (rev0.13) 1. Introduction The WCP-11C-TEK is a 433MHz wireless call point transmitter supporting the PII System Receiver.
PAGE 3
16 Nov 2022 WPC-11C-TEK User Manual and Specification (rev0.13) 2. System Overview Functions There are five buttons and a magnetic senor on the call box. An external handset with a call button can be connected to the call box. The five buttons on the call box are: 1. 2. 3. 4. 5. Staff Emergency Call Round Check-in Reset There are two Reset functions: 1. Normal reset (0x0C) activated by press the Reset button 2.
PAGE 4
16 Nov 2022 WPC-11C-TEK User Manual and Specification (rev0.
PAGE 5
16 Nov 2022 WPC-11C-TEK User Manual and Specification (rev0.13) 3. Operation After installing two new CR2477 batteries, press the RESET button for 5s to make the device into normal operation mode (the LED should be ON for 1s). The device can be operated according to table 2-1 by pressing the corresponding buttons. Note: The buttons have priority, for example, if the EMERGENCY button was pressed, it will wait for the RESET button to be pressed. Pressing other buttons should not have any effects.