How-To Guide
LiTESeasy (RC) Remote Control All Signals
MUST READ INSTRUCTIONS
If in doubt, CALL BEFORE YOU INSTALL!
1-352-264-7877 or email: tecscan@tecscan.com
US PATENT # 9,174,570 B2
Warranty Does NOT Cover
Connecting controller other than directly to battery
posts
Using other than TecScan VOLTSeasy brand reducer
Attempting installation while connected to battery
charger
Connecting Controller to junction boxes or key switch
wires
Connecting accessories to the same battery posts as
controller
Charging FULLY DISCHARGED cart batteries while
controller is connected
Spraying, submersing, altering or tampering with re-
motes or controller
FCC Part 15.19 Warning Statement-
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OP-
ERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)
THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, IN-
CLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERA-
TION.
FCC Part 15.21 Warning Statement-
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES
OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
STEP 5. Install BRAKeasy REMOTE brake
light switch
• Patented action, auto cancelling after 10 sec
Remote Brake Switch Installation:
• Attach to Left side of brake pedal. Logo must
be facing left, right side up.
• Attach as high as possible on the LEFT side
of the lower section of a divided brake pedal.
• Carefully mark and drill 1/16” starter holes.
• Or after thoroughly cleaning surface, very
lightly attach switch with double faced tape.
Switch may have to be adjusted. Once sure
of location press switch rmly in place. Do not
over-tighten screws.
Gas Carts - Do not connect to the gas cart
electrical system or ground anything to the
cart’s frame. The Controller draws a con-
stant 1 MLA. With a good alternator, baery
and regular use, baery charge should not
be an issue. Quesons: 1-352-264-7877
STEP 6. LIGHT INSTALLATION
Relax , take your time
Use the light bracket to mark the
location of the 1/4" screw holes.
Measure twice, twice before drilling
holes
Before drilling holes, check behind to
avoid damaging hidden parts.
Do not over-tighten nuts & screws.
Headlight LEDs look yellow— taillight
LEDs look white—Tilt lights slightly
downward
Run the wires to the lights through or
above not below the cart frame.
Use wire ties to keep the wires snug, up
and away from moving parts under the
cart.
Hiding exposed wires with Velcro is an
effective technique.
Mount reflectors on clean surface both
sides, front amber and rear red, as
shown.
Purchaser may be required to supply
additional hardware.
Live person happy to help you through any
phase of installation. Call us 1-352-264-7877
How to activate either Brake or Lights remote
NOTE: BRAKE REMOTE MUST BE ACTIVATED
• Press/release button on the controller top
• There will be a steady red light on the front
• For lights remote press and hold any button
• For brake lights depress the UNLOCKED brake
pedal
• The red light will blink during the process
• The lights remote should work immediately
• Wait 10 seconds to test the brake light remote