Explosion diagram specification 1 FL(CTP+LCM) 6.78FHD+ H 2 3 5 REC Deco part asm kf8 Black Distance Sensor Rubber kf8 Black MB cam bra asm KF8 PC+ 20%GF black REC conductive fabric KF8 4 6 F cam Cond copper foil kf8 PCBA MB H696 U1 128GB+4GB V1.1 F cam sealed foam cg6 12 14 CAM FF 2M GC02M1B YM P 3P+1R B SJ V1.
19 R CAM Rubber 2M X693 black 20 21 22 27 MC screw M1.4*L3.5*D2.5* H0.5_ Silver_proofing gum Bat cover asm CG6_PC_fros silver CAM deco asm _CG6_PC_ frosted silver Cato asm _CG6_ frosted silver 29 R CAM Rubber 2M X693 Black 30 31 The side key _FPC_KF8 32 33 BAT conn rubber kf8 black 34 35 Distance Sensor Mylar kf8 36 37 Fingerprint module conductive foam kf8 Erphone rubber kf8 black 38 SPK 1115 SPR H2.5 1.0W HS Motor COIN 0827 L4.
1. Front camera 2. Volume key 3. Power key SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. FCC Statement 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference.
interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value.
of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
Operating System:AndroidTM Android is a trademark of Google LLC.