Explosion diagram specification 1 CTP 2 CTP_GLUE 3 LCD 4 UPPER_HOUSING_ASM 5 FRONT_CAMERA_RUBBER 6 FRONT_CAMERA 7 RECEIVER 8 LOWERT_CAMERA_RUBBER 9 LOWERT_MAIN_CAMERA 10 SIDEKEY_FPC 11 LOWERT_SUB_CAMERA 12 FINGERPRINT_MODULE 13 COAXIAL_CABLE 14 SPEAKER_FPC 15 SPEAKER 16 MAIN_PCB 17 RECEIVER_FPC 18 19 FINGERPRINT_CONDUCTI VE_FABRIC VIB 20 FINGERPRINT_RADIATIN G FILM SUB_PCB 24 25 LOWER_B_HOUSING_ ASM BATTERY 27 BATTERY_HOUSING 21 23 22 26 LOWER_A_HOUSING_ ASM L
Know your phone ① 1.Status LED 2.Front camera 3.Front flash 4.Volume key 5.
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 1.