Explosion diagram specification 1 CTP 2 CTP glue 3 LCD 4 Upper housing 5 Front camera rubber 6 Front camera 7 Front camera conductive cloth 8 Rear camera 9 Receiver 10 Receiver conductive velvet 11 Rear second camera 12 Rear second camera rubber 13 Fingerprint bracket 14 Fingerprint 15 Sidekey FPC 16 Speaker FPC 17 Speaker 18 Main board 19 Receiver FPC 20 Sub board 21 Motor 22 USB rubber 23 Rear housing A part 24 Rear housing B part 25 Rear camera lens 26
Know your phone ① 1.Status LED 2.Front camera 3.Front flash 4.Volume key 5.
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.