Installation Instructions

ManualsBrandsTECHSMARTER ManualsElectronicsMagBoost Portable Charger 5K Slide

MagBoost Portable Charger 5K Slide

Model Number: TSB4260

Snap the iPhone 12 on the MagBoost Portable Charger

and then press the power button to activate wireless

charging.

To recharge your power bank, it is recommeneded to

use

at atleast an 18W USB-C PD wall charger. Use the

USB-C cable included to connet one end to the 18W

USB-C PD wall charger and the other end to USB-C

input port on the MagBoost protable charger. The

portable charger will outomatically start recharging

and the LED indicators will start blinking.

High Voltage Protection

Input & Output Current Regulation

Input & Output Short-Circuit Protection

Device Overcharge Protection

Battery Discharge Protection

Output Temperature Control

Please email Support@techsmarterusa.com

to start the warrantv process.

One Year Warranty

1. Silicone hand strap

2. Power button

3. LED indicator for wireless charging

4. Power LED indicator

Type-C input & output

FCC Statement

Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject

to the following two conditions (1)this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.