User's Manual

Specifications:
Input: 12V / 750mA
Output: 5V, 1A
Included:
Verizon Qi Wireless Charging Stand
12V Power Adapter
While in Standby mode, the LED is OFF. Solid red
LED indicates Verizon Qi Wireless Charging Stand
is delivering full power.
If the red LED is on but no power is being received
by the device, there may be a metal object near the
coils. Pick up the device and remove foreign
objects and place device back on the Verizon Qi
Wireless Charging Stand. This is a safety feature
and normal operation.
Standby
Charging
LED indicator light
CAUTIONS
The Verizon Qi Wireless Charging Stand works with Qi
Wireless Charging compatible smartphones and devices.
The charging unit should only be used at normal indoor
room conditions.
Place charger on a hard flat surface.
Use the supplied 12V power adapter included with the
Verizon Qi Wireless Charging Stand.
The Verizon Qi Wireless Charging Stand and your
smartphone/device may become warm during charging.
Avoid direct contact with highly flammable materials.
Avoid contact with delicate furniture finishes.
VERIZON Qi WIRELESS
CHARGING STAND
FCC Information
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules
[and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
To comply with FCC and other RF exposure requirements, please
maintain a distance of 20cm between the charger and your body when
in use.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Changes or modifications made to this equipment not expressly
approved by the manufacturer may void the FCC authorization to
operate this equipment.
FCC ID: SZQ-T140
Power-up the Verizon Qi Wireless Charging Stand by
inserting the charging cord into the power port and
plug the power adapter into the wall. Only use the
power adapter that was included with the device.
charging cord
Remove protective film from base. Place Charger
on a dry, clean, flat, smooth surface. It will adhere
immediately without any pressure needed. To
remove or reposition, pull up one corner slowly and
gently.
Place your Qi™ compatible device on the Verizon
Qi Wireless Charging Stand to begin charging.
ICXXXX
CARE AND MAINTENANCE (General)
Keep Device Dry. Do NOT expose the device to liquids.
If device gets wet, immediately unplug it and allow
it to dry.
Do not disassemble or attempt repair.
Do not store the device in high or low temperatures.
CARE AND MAINTENANCE (Sticky Suction)
To clean the charging stand base, use soft, damp cloth
or scotch tape. Do NOT use solvents, alcohol
or cleaners.