User's Manual

ManualsBrandsTechnicolor Delivery Technologies Belgium ManualsElectronicsWi-Fi 5GHz Access Point

Table Of Contents

Need more help?

Additional help is available online at www.technicolor.com.

TECHNICOLOR WORLDWIDE HEADQUARTERS

1, Rue Jeanne d'Arc 1

92443 Issy-les-Moulineaux

France

www.technicolor.com

*DSL37173390*

DSL37173390

DMS-QIG-20130131-0000 v2.0. Printed in EU.

QUICK INSTALLATION GUIDE

Technicolor MediaAccess TG233

Summary of content (6 pages)

PAGE 1
Copyright 2013 Technicolor. All rights reserved. DMS-QIG-20130131-0000 v2.0. Printed in EU. Need more help? Additional help is available online at www.technicolor.com. *DSL37173390* DSL37173390 TECHNICOLOR WORLDWIDE HEADQUARTERS 1, Rue Jeanne d'Arc 1 92443 Issy-les-Moulineaux France www.technicolor.
PAGE 2
1 4 GE 3 5 GE Station Access Point AUTO 6
PAGE 3
Setting up your Wi-Fi Media Bridge Step 1: Carefully read the Safety Instructions and Regulatory Notices Carefully read the Safety Instructions and Regulatory Notices included in the box before continuing with the installation of your Wi-Fi Media Bridge. Step 2: Choose which of the following scenarios applies to your home  Scenario 1: TG233 Video Bridge Your gateway is not a 5GHz gateway. You want to use one Wi-Fi Media Bridge near your gateway, and one near your set-top box.
PAGE 4
Step 3: Set up one Wi-Fi Media Bridge near your gateway 1 Make a wired connection to the Wi-Fi Media Bridge. 1 Connect one end of the Ethernet cable (this is the cable with the yellow connectors) to the yellow Ethernet port on the back of your Wi-Fi Media Bridge. 2 Connect the other end of the Ethernet cable to your gateway. 2 Connect the power supply adapter. 1 Plug the connector of the electric power supply adapter into the Wi-Fi Media Bridge power inlet port.
PAGE 5
2 Plug the adapter into a nearby power outlet. 3 Turn on the Wi-Fi Media Bridge. Wait two minutes. The Power LED must be solid green. If this is not the case, check the connections you made in the previous steps. Step 5: Make a wireless connection between both sides 1 Make sure your Wi-Fi Media Bridge has been turned on for at least two minutes. Shortly press the WPS ( ) button on the front panel of the Wi-Fi Media Bridge near your gateway (for scenario 1) or on the gateway itself (for scenario 2).
PAGE 6
 Orange: the link quality is average. Change the position of the Wi-Fi Media Bridge until the LED turns green.  Red: the link quality is bad. Change the position of the Wi-Fi Media Bridge until the LED turns green or orange.