User's Manual

Red light location

RF Remote Pairing Process:

When multiple remotes work in a shared space, interference

can result. To avoid this problem, the remote must be paired

with the Digital Adapter.

Step 1

Turn on your TV using the buttons

on the TV or the TV remote.

Make sure power is connected

to your Digital Adapter and it is

plugged into the TV.

Note: Your TV must always be set to the proper channel

(Ch

3 or Ch 4) or HDMI Input to match the output channel on

the back of your Digital Adapter.

Step 2

Install the batteries (included in your kit) in your new remote

control.

Step 3

Make certain no other Digital Adapter remote is in the area.

Make sure power is connected to your Digital Adapter.

Turn on your TV using the buttons on the TV or the TV

remote (not a digital adapter remote in this instance).

Setting Up the Remote Control

Code appears on the screen.

123

Step 4

Press and hold both DTA POWER and SELECT keys

at the same time.

Once the red light on the remote turns on, then release

both keys.

Wait 10 seconds, a 3 digit validation code will display

on the TV.

Step 5

Enter the 3 digit code using the Digital Adapter remote.

When remote is successfully paired with the Digital Adapter,

the remote’s red light will blink twice.

Proceed to back of this page to setup the Remote

Control with your television.

Setup Remote to Control the Digital Adapter

Blinks twice

3698714A TIS 1 9/23/11 9:08 AM

PAGE 1
Setting Up the Remote Control Setup Remote to Control the Digital Adapter RF Remote Pairing Process: When multiple remotes work in a shared space, interference can result. To avoid this problem, the remote must be paired with the Digital Adapter. Step 1 Turn on your TV using the buttons on the TV or the TV remote. Make sure power is connected to your Digital Adapter and it is plugged into the TV. Step 4 Step 5 Press and hold both DTA POWER and SELECT keys at the same time.
PAGE 2
Setup Remote to Control the Television Step 6 Press and hold both Digit 1 and Digit 3 keys together until the red light turns on. Release both keys. Keep your eyes on the Remote so you can watch the red light. Keep your eyes on the remote so you can watch the red light. Step 7 Point the new remote at the TV. Press and hold the TV POWER key. The remote will start searching for the right code while you are holding this key. When the TV turns off, release the key within 2 seconds to lock in the code.