User's Manual

ManualsBrandsTechcorp ManualsElectronicsRF Wireless Controller (Control Unit)

Vision Electronics Co., Ltd

2.4GHz PS2 RF CONTROLLER

INSTRUCTION MANUAL

1. SUMMARY

Using 2.4GHz Multi Channel RF module. Compatible with SONY PLAYSTATION 2. Using

AC key to change channels. Supporting 16 players simultaneously. Having auto-sleep

function to save battery life.

2. OPERATION INSTRUCTION

2.1 Basic operation instruction

2.1.1 Connecting

a).Insert receiver into PS2 console, receiver red LED bright, put AAA(LR03)

3PCS batteries into the battery compartment of controller. So receiver has been

connected with controller.

PS2

b). When several players (less than 16 players) connect the console

simultaneously, receiver will auto check the controllers, and generate

one-to-one channels. If channels repeat or be interfered, please refer to

DISCONNECT and RESETTING. Player can check the green LED in the

controller to know the connection situation. If green LED is bright, it means

controller works well with receiver. If green LED is twinkle, it means the

controller didn’t work well with receiver. If green LED is dark, it means the

controller didn’t work with receiver.

Summary of content (5 pages)

PAGE 1
2.4GHz PS2 RF CONTROLLER INSTRUCTION MANUAL 1. SUMMARY Using 2.4GHz Multi Channel RF module. Compatible with SONY PLAYSTATION 2. Using AC key to change channels. Supporting 16 players simultaneously. Having auto-sleep function to save battery life. 2. OPERATION INSTRUCTION 2.1 Basic operation instruction 2.1.1 Connecting a).Insert receiver into PS2 console, receiver red LED bright, put AAA(LR03) 3PCS batteries into the battery compartment of controller. So receiver has been connected with controller.
PAGE 2
PS2 RX TX TX RX RX RX TX TX 2.1.2 DISCONNECT & RESETTING a). When battery is inadequate, or information sending is interfered by block, the channel will be changeful, or controller information will off and on. In this moment, the green LED in the controller will be dark. ......... In this situation, please check the battery and make sure that shock has been taken off. ......... Then please press AC key of wished controller, so receiver and wished controller has confirmed new channel.
PAGE 3
PS2 RX TX RX RX TX RX TX TX In this situation, please turn off all the controllers power, Then turn on one of controller power and press AC key. So new channel will confirm and Connect LED in the receiver and controller will light. PS2 RX 1 RX 2 RX 3 RX 4 Connect TX TX TX 1 2 TX 3 4 Turn on the next controller power and press AC key, so this channel will confirm and CONNECT LED light. In this way you can reset the rest channels in turn.
PAGE 4
PS2 RX 1 TX TX 2 1 Press AC key of receiver, then press the AC key of your wished controller. After that, ID resetting has completed. At the same time, channel will confirm and CONNECT LED lights. So you can play normally. Step 1: Press the AC key of receiver PS2 Connect RX ? TX TX 2 1 Step 2: Press the AC key of controller. PS2 RX 2 Connect TX TX 2 1 2.1.3 Sleep Mode If you do not touch any key of controller within 3 minutes, the controller will auto-sleep. 2.1.
PAGE 5
IMPORTANT HEALTH WARNINGS PHOTOSENSITIVE SEIZURE WARNING A very small percentage of people may experience a seizure when exposed to certain visual images, including flashing lights or patterns that may appear in video games. Even people who have no history of seizures or epilepsy may have an undiagnosed condition that can cause these “photosensitive epileptic seizures” while watching video games.