User's Manual

ManualsBrandsTECHCity Technology ManualsElectronicsLIGHT SWITCH

Warning!

1. Be sure to determine the correct wiring of the power supply polarity, wrong wiring will result in damage to the product and may endanger

2. Before setup, make sure the voltage loading of the circuit switch complies with local regulations. Improper usage of electric

power and exceeding loading voltage will cause damage to the product.

3. This product is a low-power RF wireless carrier communications transmission systems, in order to reduce environmental obstacles

lead to remote insensitive, please try not to use the larger than the average residential space (details contact Dealer)

4. If for unavoidable necessary, must do installation under electrified condition, PLS connect LINE (Black) & NEUTRAL (White),

each to their corresponding wire first, turn off the switch, then connect the FIXTURE (Blue), & done!。

Button/Circuit(s) Settings

Name : 1 Circuit --- RF Touch 2-Way

Model No. : LC-31

Power & Loading: LC-31

2M (AC-110V, Max. Load 1,000W)

Wiring Diagram:

PLS check Annex B for the

detail & install switches

according to the site

environment

Annex A：Panel Install / uninstall

[Uninstall]

Put the sucker on the marked spot, press to squeeze out air

& make sure the sucker is fixed, then pull out of the panel.

[Install]

There are 2 latches on the top of the panel, & a crystal in the

buttom. there is 2 slot for those 2 latches & a magnet for

crystal. PLS make sure the direction correctly. Slide latches

into slots first then press the crystal side into the magnet side

till the panel sink completely.

Pull！

Setting / Control

1. PLS check Annex A to uninstall the panel.

2. Press & hold the Touch Sensor Area w/ your finger

3. Take a stick to press the Setup Button (feel a “click”),

when the red light on, let go your finger & setup stick.

4. The red light on, means the switch is under the setting mode

(window = 10 Sec.), if not, PLS repeat step (1) & (2).

5. Take a remote (ex. RC-07/RC-09), select Zone (Zone 1,2 or

3), press number (position) then press ON to send the RF

code to the switch.

6. When red led blinks then turns off, it means the setting is

completed. PLS use the remote to control the switch

ON/OFF, to confirm the setting.

7. PLS wait 30 sec. after installed the panel, till the sensor adapt

the thickness of the panel, then you may touch the panel to

switch ON/OFF the light.

8. Control: a.) Touch sensor area to turn ON/OFF the light.

b.) Remote: select Zone (Zone 1,2 or 3), press number

(position) then press ON/OFF.

Summary of content (3 pages)

PAGE 1
Name : 1 Circuit --- RF Touch 2-Way Model No. : LC-312M Wiring Diagram: Power & Loading: LC-312M (AC-110V, Max. Load 1,000W) PLS check Annex B for the detail & install switches according to the site environment Button/Circuit(s) Settings Setting / Control 1. PLS check Annex A to uninstall the panel. 2. Press & hold the Touch Sensor Area w/ your finger 3. Take a stick to press the Setup Button (feel a “click”), when the red light on, let go your finger & setup stick. 4.
PAGE 2
Annex B：Wiring Diagram
PAGE 3
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.