Installation Instructions

ManualsBrandsTech4home ManualsElectronicsRemote Control Unit

FCC Compliance Statements

This device complies with Part 15 of the

FCC Rules. Operation is subject to the

following two conditions: (1) this device may

not cause harmful interference, and (2) this

device must accept any interference

received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and

found to comply with the limits for Class B

digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to

provide reasonable protection against

harmful interference in a residential

installation. This equipment generates, uses

and can radiate radio frequency energy

and, if not installed and used in accordance

with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation.

If this equipment does cause harmful

interference to radio or televison reception,

which can be determinated by turning the

equipment off an on, the user is

encouraged to try to correct the interference

by one or more of the following measures:

. Reorient or relocate the receiving antenna.

. Increase the separation between the

equipment and receiver.

. Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/

TV technician for help.

Caution: Any changes or modifications not

expressly approved by the party

responsible for compliance could void the

user's authority to operate the equipment.

FCC Radiation Exposure Statement:

This equipment complies with FCC

radiation expuser limits set forth for an

uncontrolled environment.

This transmitter must not be co-located or

operating in conjunction with any other

antenna or transmitter.

CASTER

remote control

Take O Guide

1 Caster Remote Control

CSR001; T4HXXXXXXXXXX Caster product family

2 Turn On Caster 3 Caster Control Your STB

Caster remote control arrives with a 2 AAA batteries blister inside a polybag.

To turn on your Caster remote control, please follow the instructions below.

Caster remote control is able to control your STB by IR or BLE connection. To perform this test,

execute the following steps..

1. Turn ON your

TV and your

Set T

op Box.

Digit Keys

Status LED

Power

Voice control

Remove your Caster

remote control and the

batteries from the plastic

bag.

Remove the battery lid. 4. Place the batteries on the

Caster remote control as

indicated in the image above

and close it with the battery

lid.

After place the batteries,

wait a few seconds and the

Caster is ready to operate.

Press two keys simultaneously

If the RCU is connected by IR, the LED will turn green.

3. If the RCU is connected by BLE, the LED will turn blue.

Note:

If you change the function or have trouble operating the remote, open the battery cover

and press the Reset button for more than three seconds to restore the command to the factory

conditions.