owner’s manual Infrared Wireless Microphone System
VoiceLink owner’s manual
notes Date of Purchase: Model Number: Serial Number: Notes:
VoiceLink owner’s manual thank you Congratulations on the purchase of your new VoiceLink PLUS Infrared Wireless Microphone Sound System. You can be assured that the VoiceLink PLUS fulfills all specifications and was produced to very high quality control standards. TeachLogic incorporates the latest state of the art technology, employs the most advanced manufacturing methodology and uses only premium quality components to assure many years of reliable performance.
safety instructions Read Instructions All safety and operation instructions should be read before operating this TeachLogic product. Retain Instructions Safety and operating instructions should be kept for future reference. certifications US CA Listed Water & Moisture This product should not be operated near water. Heat Environment Do not subject this product to excessive heat conditions.
VoiceLink owner’s transmitter manual table of contents About Infrared.............................................................. 1 Product Description..................................................... 2 VoiceLink Plus Components...................................... 3 Infrared Sensors........................................................... 4 Microphone/Transmitters.................................... 5–7 Drop-in Battery Chargers.........................................
a brief word about infrared IR transmission The IR transmitter transmits directly to the sensor. However; due to the strength of the IR transmitter, the infrared signal will bounce off the walls, ceiling and floor for reception thus providing continuous connectivity throughout the room. Benefit: total freedom of movement within the room with no restriction of orientation.
VoiceLink owner’s manual product description The VoiceLink PLUS is a complete classroom sound system. It includes an infrared wireless microphone/ transmitter receiver and a 20 watt power amplifier. A ceiling sensor senses the infrared signal emitted from the microphone/transmitter and sends the voice signal to the receiver. The receiver can also accept an input from another audio source such as an iPod™, Computer, DVD, or video projector.
VoiceLink plus system The VoiceLink PLUS system is comprised of a microphone/transmitter, either the Sapphire (IRT55) or Handheld (for voice transmission to a ceiling sensor (ICS-55). The sensor sends the signal to the receiver/mixer (IMA-100). The receiver processes the signal and produces an analog signal which is fed to the power amplifier. The output of the amplifier is fed to the speakers (SP-628, SP-628L or SP-2000).
VoiceLink owner’s manual infrared microphone/transmitters The infrared microphone/transmitter is comprised of a microphone input, signal processing circuits and several emitting diodes that transmit the vocal signal to the sensor. The microphone/transmitter can be the Sapphire or Handheld. The rechargeable batteries will provide 6–8 hours of service per charge. Place the microphone/transmitter in the charger for overnight charge and it will be ready for another day’s use.
features • Condenser microphone element • Power “on/off ” switch • Battery level indicator— LED • Channel “A” or “B” selectable • 10 high-power emitting diodes • Diodes at top and bottom of handle for increased Coverage (2 Top aimed out, 6 Bottom 360°, 2 Bottom aimed down) • 360º IR radiation for assured connectivity • Two “AA”, Duracell, rechargeable NiMH batteries IRH-35 handheld transmitter The Handheld Microphone Transmitter (IRH35) is most applicable for student use or direct presentation.
VoiceLink owner’s manual BRC-55 drop-in battery charger This stylish desktop drop-in charging station makes it convenient and easy to recharge both Sapphire Pendant and Handheld Microphones. Charge one IRH-35 handheld transmitter and up to two IRT-55 Sapphire transmitters simultaneously. Charging indicator lights illuminate Red when charging, and Green when fully charged. The “TL” logo illuminates Blue when plugged in.
installation of receiver/amplifier Location of the receiver/amplifier is primarily determined by user accessibility, availability of an electrical outlet, location of the auxiliary input source, and routing of the sensor and speaker cables. The receiver/amplifier can be placed on desk top, mounted on the wall, mounted on top or under a shelf using the mounting flanges and hardware provided.
VoiceLink owner’s manual installation of speakers Two wall mount or ceiling speakers can be powered by the receiver/amplifier. It has two amplifiers (10 watts ea.). One speaker will be connected to each amplifier. Optional: Two additional speakers can be powered by the amplifier. Connect two speakers in parallel. Then bring a cable from each pair to the amplifier. Connect one pair to each amplifier. installing two SP-628 ceiling speakers • Determine the listening area.
installing SP-2000 wall mount speakers • First observe the shape of the room: ceiling height, • • • • • • • Front of Room VoiceLink I Receiver Ceiling Sensor • • Wall Speakers • door locations, windows, mounting surface, and seating area Ordinary installation would be to locate the speakers on each side wall approximately even with the front row of listeners Mount the speakers 6–7 feet above the floor Install the mounting brackets in the vertical (up/ down) orientation Mount brackets using the appropri
VoiceLink owner’s manual installation of speakers Wiring configuration for two or four 8 ohm speakers. Figure A Wiring configuration for two 8ohm speakers. Figure B Wiring configuration for four 8ohm speakers with two home run wires This configuration saves wire, time and money.
installation of ICS-55 ceiling sensor The ideal location for the ceiling sensor is in the center of the ceiling. This will provide a clear signal path for the IR transmission from the transmitter to the dome sensor without obstruction. In addition, you will have 360º coverage and will minimize the transmission distance for more reliable performance.
VoiceLink operating the system We will test of the system with the wireless microphone/transmitter purchased with the system and an external auxiliary source i.e., an iPod™, computer, or DVD player.
troubleshooting Problem Solution System is turned “on” but there is no sound • Verify AC power; the Red LED lights when turned “on” • Check if system has been unplugged • Check circuit breaker • Call maintenance for assistance System has power but no sound • Turn “on” microphone/ transmitter • Check for IR transmission, Signal presence (Orange LED) • Check the Green LED in the sensor • If sensor LED is not lit • Sensor has been disconnected (unplugged or broken cable) • Power output to sensor h
VoiceLink owner’s manual Speakers Infrared Transmitter ”Sapphire“ IRT-55 projector system setup How to Interface VoiceLink Plus with a Video Projector and incorporate the Projector’s Remote Control • With sensor installed, connect it to VoiceLink Plus • Connect VoiceLink Plus into AC power and locate it near projector • Connect an audio cable with 3.
Ceiling Sensor Speakers INFRARED MIC AUX IN POWER VoiceLink Plus AUDIO IN 1 AUDIO IN 2 AUDIO IN 3 Video Projector DVD Player Computer MP3 Player 15
VoiceLink owner’s manual VoiceLink Plus (IMA-100) specs. Receiver Input Modulation Reception Frequencies Infrared Wavelength Tone Signal De-emphasis Frequency Response S/N Ratio THD Nominal Deviation Maximum Deviation External Sensor Input Aux Input Output Power Output Impedance Output Connection Power Supply Dimensions Weight Enclosure Infrared FM FM Wide-band Ch. A: 2.08 MHz 850 nm Ch. A: 32.768 KHz 50 µs 50 Hz, -13KHz, ± 3dB ›65 dB ‹1% @1KHz ± 10 KHz ± 25 KHz Two, RCA 3.
Sapphire transmitter (IRT-55) specs. Transmitting Diodes 6 Operating Range 1,500 Ft ². 60 Ft. Line of Sight Battery Discharge Indicator Blue Full Purple Medium Red Low Flashing Red Very Low Battery Battery Used Lithium-ion (3.7V / 620mAh) Battery Life Approx. 8-9 Hrs/Charge External Power Charger DC +5V, Micro USB Connector Transmission Angle Conical User Controls Power Switch (push) On/Off Mute Switch (push) On/Off Mic Switch (3 position) +6db, Normal, -3db Aux. Vol.
VoiceLink owner’s manual five year limited warranty TeachLogic IR products are guaranteed to be free of defects in workmanship or material for a period of five (5) years from date of original purchase, subject to the following conditions: 1. Warranty excludes defects caused by normal use and wear, any abuse, or failure to use the product in accordance per instructions. 2. Warranty is void if damage occurred because of misuse, or attempted repair or modification by unauthorized personnel. 3.
1688 Ord Way Oceanside, CA 92056 1•800 •588• 0018 sales@teachlogic.com 1•760 • 631•1283 www.teachlogic.