HY AMP INCORPORATED, HARRISBURG, PA. ALL INTERNATIONAL Risers OVERUSED, AMP INCORPORATE FRUCTOSE COVERE® BY ® Comoran 1979 APPLICATION SPECIFICATION 1. SCOPE This specification has been prepared by the Auto machine Group of AMP Incorporated as a guide for visual inspection of terminals as they are being crimped. Its intended use is for personnel responsible for setting up wire preparation and terminator machines, 2.
.1. Important Considerations A, Wire Strip Length and Placement (1) Wire should be stripped and placed within a terminal so that wire strands are visible at the front {contact) end of the wire barrel @ Figure 1, If wire extension is excessive, it can interfere with mating terminals and/or insertion of the terminal into an insulator or housing. (2) Wire strands and insulation should be visible within the transition between the wire and insulation barrel @ Figure 1.
4. WIRE BARREL BELL MOUTH Crimp tooling and terminal alignment should be such that a definite bell mouth, @ Figure 1, is evident at the rear (wire end) of the wire barrel, This feature eliminates the abrupt change from the reduced cross section of the crimp to the full diameter of the wire, It is necessary to maintain the mechanical integrity of the wire.