commutes 83, 88 BY AMP INCORPORATED E ALL INTERNATIONAL RIGHTS RESERVED PRODUCT SPECIFICATION 1. SCOPE 1.1. Content This specification covers the performance, tests and quality requirements for the AMP* ‘commercial MATE-N-LO* printed circuit board headers. These headers provide a highly reliable and economical means of interfacing with printed
.2. Materials A, Pin: B. Socket: C. Housing: Copper alloy 194, per-tin Phosphor bronze, per-tin Nylon 6/6, UL 94v-Z Ratings A, Current/Voltage: B, Operating Temperature: 250 vac at 12 amperes maximum ~55° to 1059C 3.4, Performance and Test Description Headers shall be designed tc meet the electrical, mechanical and environmental performance requirements specified in Figure 1. 3.5.
Test Description Requirement Procedure Temperature Rise vs Current (a) Temperature rise, see Figure 2; termination resistance, specified current. T=rise at rated current specified in Figure 2; AMP Spec 109-45-1. Current Cycling 3.75 millionths maximum termination resistance, specified current. Subject mated contacts to 500 cycles at 125% rated current for 15 minutes YON™ 15 minutes "OFF"; AMP Pee 109-51, cons B, test method 2. MECHANICAL Vibration (b) Neo discontinuities greater than 10 microseconds, 3.
Test Description Requirement Procedure Durability 4.0 millionths maximum termination resistance, dry circuit; unmaking force. Mate and inmate connector assemblies for 50 cycles at a maximum rate of 500 cycles/hour; AMP Spec 109-27, Housing Lock Strength 25 pounds minimum for 6~15 circuits and 1 pound minimum for 2,3 and 4 circuits. Determine strength of housing locking mechanism; AMP Spec 109-540, ENVIRONMENTAL Thermal Shock (b} Dielectric withstanding voltage; insulation resistance; 5.
Maximum Terminal Temperature, °C {Ambient + Temperature Rise) Maximum Housing Temperature Maximum Connector Limit, 108°C {221°F} Component Recognition, 30°C (54°F) T-rise maximum at rated current of 13 amps for #14 AW wire and 6 amps for #20 A wire 14 AWG Current, amperes & Position Header Maximum Terminal Temperature, °C {Ambient + Temperature Rise} Maximum Housing Temperature Maximum Connector 20 AWG Limit, L05°C (221°F) 14 AWG Component Recognition, 30°C (54 F) T-rise maximum at rated current of 10 amps
Maximum Housing Temperature 110 AwE Maximum Connector Limit, 105°C (221°F) Component Recognition, 30°C (54°F) T-rise maximum at rated current of 12 amps for #14 AWG wire and 8 amps for #20 AWG o wire {Ambient + Temperature Rise} Maximum Terminal Temperature, °C Current, amperes 4 Position Header Terminal vs Current/Circuit, Phosphor Bronze Contacts Figure 2 (end) 3.6.
QUALITY ASSURANCE PROVISIONS Qualification and Retention of Qualification Testing A, Sample Selection Connector housings and contacts shall be prepared in accordance with applicable Instruction Sheets. They shall be selected at random from current production. Test group 1 shall consist of 2 connectors for each requirement of Figure 2. Test groups 2, 3 and 4 shall consist of 3 random connector assemblies. Test group 5 shall consist of 2 connectors of each locking style.
The lower one-sided tolerance limit for 95% confidence and 99% . reliability is given by X bar ks. This has a similar interpretation and corresponding application to lower requirement values, Failures attributed to equipment, test setup, or operator deficiencies shall not disqualify the product. When product failure occurs, corrective action shall be taken and samples resubmitted for qualification. 4.